COMPATIBILITY AND ACIDIFYING AGENT

General Information

GENERAL INFORMATION

COMPLETE COMPATIBILITY is an anionic formulation that aids in the blending of liquid fertilizers with pesticides and pesticide tank mixes. COMPLETE COMPATIBILITY will improve pesticide coverage and efficacy.

COMPLETE COMPATIBILITY may be used with pesticides registered for use on all agricultural, forestry, industrial, non-cropland, rights-of-way, turf and municipal, and other uses.

For Terrestrial Use Only – Not for Aquatic Use

IN EVERY CASE, THE PESTICIDE LABEL PRECAUTIONS MUST BE FOLLOWED AND THIS PRODUCT MUST BE USED IN ACCORDANCE WITH PRODUCT LABEL DIRECTIONS.

NOTE: When applying aerially, follow pesticide label directions including minimum water volume per acre. Do not substitute COMPLETE COMPATIBILITY for water required by the pesticide label.

Refer to 'pH Recommended Use Chart' on the label to determine the approximate quantity of COMPLETE COMPATIBILITY to be added to reduce the pH of 100 gallons of water.

Limitations, Restrictions, and Exceptions

APPLICATION ON PESTICIDE TANK MIXTURES:

Problems can occur with fertilizer and pesticide combinations because of different physical and chemical properties in the tank mix. Some types of problems are inadequate dispersion, wetting, emulsion or solution stability and lumping. To determine the need for this product or insure that problems with the tank mix are minimized, follow the testing procedure described below:

IN THIS TEST, ONE TEASPOON PER GALLON IS EQUAL TO APPROXIMATELY ONE PINT PER 100 GALLONS FOR PESTICIDE AND LIQUID FERTILIZER TANK MIXES.

COMPLETE COMPATIBILITY may be tested before use with liquid fertilizer and/or pesticide tank mixes as follows:

1. Measure one gallon of liquid fertilizer or water in a clean clear container.

2. Add one teaspoon of COMPLETE COMPATIBILITY (1 pint rate) to the liquid and mix well.

3. Add pesticide to the solution and shake well to mix.

Allow the mixture to stand for at least 15 minutes. If the mixture is oily or lumpy instead of smooth, repeat the test using the same amount of fertilizer and/or pesticide, and increase the amount of COMPLETE COMPATIBILITY to two teaspoons (2 pint rate) and mix. The solution should remain stable for at least 30 minutes. If this does not solve the problem, increase the amount of COMPLETE COMPATIBILITY to three teaspoons (3 pint rate). If the problem cannot be corrected, sometimes making a pre-mix of the pesticide and liquid fertilizer or water and adding it last can help, especially in the case of a wettable powder.

COMPLETE COMPATIBILITY may be added to fertilizer grades as follows:

1 to 3 pints per 100 gallons

--- 25-0-0, 28-0-0, 30-0-0, and 32-0-0

2 to 3 pints per 100 gallons

--- 20-20-20, 20-5-5, 15-15-0, 15-10-8, 15-10-6, 12-48-8, 12-12-8, 10-34-0, 10-24-0, 10-15-5, 10-5-5, 8-24-0, 8-16-8, 7-21-7, 6-16-6, 5-23-5, 5-10-10, 4-10-10, 5-20- 12

The best method of use is to add the COMPLETE COMPATIBILITY to the fertilizer with the agitation on before adding the pesticide.

Apply as soon as possible after mixing. If mixture is allowed to stand for any length of time, check to make sure the mixture is still smooth and agitate before using.

Method
Timings