General Information


Do not apply directly to water, or to areas where surface water is present or to intertidal areas below the mean high water mark. Do not contaminate water when disposing of equipment washwater or rinsate.

Dimethoate is known to leach through soil into ground water under certain conditions as a result of label use. Use of this chemical in areas where soils are permeable, particularly where the water table is shallow, may result in ground-water contamination.

This product may contaminate water through drift of spray in wind. This product has a high potential for runoff for several days after application. Poorly draining soils and soils with shallow water tables are more prone to produce runoff that contains this product.

A level, well maintained vegetative buffer strip between areas to which this product is applied and surface water features such as ponds, streams, and springs will reduce the potential for contamination of water from rainfall-runoff. Runoff of this product will be reduced by avoiding applications when rainfall is forecasted to occur within 48 hours.

A vegetative filter strip constructed and maintained in accordance with the 2000 Natural Resources Conservation Service publication “Conservation Buffers to Reduce Pesticide Losses” (http://www.nrcs.usda.gov/feature/buffers/) will significantly reduce the potential for contamination of water from rainfall-runoff.

This pesticide is toxic to wildlife and aquatic invertebrates.

This product is highly toxic to bees exposed to direct treatment or residues on blooming crops or weeds. Do not apply this product or allow it to drift to blooming crops or weeds if bees are visiting the treatment area.


Do not use this product for any other uses than those specified on the label. This product is intended for use by the commercial grower or commercial applicator in conventional hydraulic sprayers, ground applicators, airplane sprayers, or by chemigation.

GROUND APPLICATION: Use recommended amount in sufficient water for thorough coverage.

AIR APPLICATION: Use recommended amount in 2 to 10 gallons of water, unless otherwise specified. Repeat applications as necessary unless otherwise specified.

Consult your State Experiment Station or State Extension Service for proper timing of applications.

High Pressure Handwand Equipment: When applications are made by high pressure handwand equipment, the maximum application rate for all crops and use-patterns is 0.0025 pounds active ingredient per gallon.

Limitations, Restrictions, and Exceptions

Use a 1:2 dilution (1 part Dimethoate 267 to 2 parts water). Apply using a low-pressure injector. Inject 1 1/4 fl.oz. of dilution 6 inches below ground for each 1/2 inch of trunk diameter. Do not apply to plants that have not been established for at least 3 years.