MORE SUSCEPTIBLE WEEDS
Drift or runoff may adversely affect nontarget plants. Do not apply directly to water, or to areas where surface water is present or to intertidal areas below the mean high water mark. Do not contaminate water when disposing of equipment washwaters nor pour washwaters on ground; spray or drain over a large area away from wells and other water sources. Do not apply this product through any type of irrigation system. Use care to avoid spray contact or drift to susceptible plants such as beans and other legumes, cotton, flowers, grapes, ornamentals, vegetables and other plants. Do not permit spray mist containing this product to drift onto them since even very small quantities of the spray, which may not be visible, can cause severe injury during both growing and dormant periods. Do not spray when the wind is blowing towards susceptible crops or ornamental plants. Use coarse sprays to minimize drift. Spray drift can be lessened by keeping the spray boom as low as possible; by applying 20 gallons or more of spray per acre; by using no more than 20 pounds spraying pressure with flat fan or flooding flat fan nozzle tips; by spraying when wind velocity is low; and by stopping all spraying when wind exceeds 8 miles per hour. Do not apply with hollow cone-type insecticide or other nozzles that produce a fine droplet spray. Do not use the spray equipment for applying other materials to susceptible crops as injury may result.
Most cases of groundwater contamination involving phenoxy herbicides such as MCPP-p have been associated with mixing/loading and disposal sites. Caution should be exercised when handling MCPP-p pesticides at such sites to prevent contamination of groundwater supplies. Use of closed systems for mixing and transferring this pesticide will reduce the probability of spills. Placement of the mixing/loading equipment on an impervious pad to contain spills will help prevent groundwater contamination.
DIRECTIONS FOR USE
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.
This product may be used on ornamental turf grasses with greater safety than 2,4-D. Not for use on turf being grown for sale or other commercial use as sod, or for commercial seed production, or for research purposes.
This herbicide is safe to use on Washington, Toronto and Seaside bentgrasses, Kentucky and Merion bluegrasses. Apply this product on a warm calm day when weeds are growing vigorously. Use any suitable sprayer or watering can with fine nose to give a uniform cover of the weeds. Although this herbicide is relatively slow in action, it gives a superior result on more difficult to control weeds such as:
TIME OF APPLICATION: To obtain the best results, this product must be applied when the weeds are most susceptible and conditions are such that no damage to the grasses will occur. Apply this product when the weeds are growing vigorously. During periods of drought, weeds become more resistant to herbicides. Under the same conditions, fine grasses are more susceptible to this product, particularly when temperatures exceed 90oF. This chemical is absorbed by the foliage of broadleaf weeds and is translocated throughout the whole plant to roots, etc. where it eventually causes death of the plant. Do not cut or mow the lawn 2 to 3 days before or after treatment so that maximum uptake and translocation can occur. Do not spray if rain is likely, otherwise the chemical may be washed off before absorption has taken place. For the same reason, do not water the lawn for at least 24 hours after application.
Better control of the weeds classified as Less Susceptible Weeds may be obtained with repeat applications of half the recommended dose carried out at not less than monthly intervals.
This product is not recommended for St. Augustine grass and Centipedegrass, as it can cause damage to these species. Do not use this product on newly sown lawns or turf until grasses are well established. Reseed no sooner than three to four weeks after application of this product. Avoid drift onto other plants and do not use the first cuttings after treatment as a mulch for flowers and vegetables.