NON-AGRICULTURAL USES - BROADLEAF WEEDS CONTROL AT 8-12 LBS/ACRE
Bromacil/Diuron 40/40 is a selective herbicide for use in citrus and in noncrop areas. Bromacil/Diuron 40/40 controls many annual weeds at lower rates and perennial weeds at the highest rates allowed by the label.
As this product must be absorbed through the root system of weeds, best results are obtained if treatment is made just before or after weeds have germinated to moist soil and moisture is supplied by rainfall or sprinkler irrigation within two weeks of application. Weed control symptoms are slow to appear and may not become apparent until the chemical has been carried into the root zone of the weeds by moisture. The degree and duration of control will vary with the amount of herbicide applied, rainfall, soil texture, and other soil and water management practices.
USE PRECAUTIONS AND RESTRICTIONS
To avoid injury to or loss of desirable trees or other plants, observe the following use guidelines:
- Do not apply this product using any type of irrigation system.
- Aerial application is prohibited for all uses except for rights of way.
- Except as instructed, do not apply or drain or flush equipment on or near desirable trees or other plants, or on areas where their roots may extend, or in locations where the chemical may be washed or moved into contact with their roots.
- Do not use in any recreational areas or in or around homes, in home fruit plantings, on lawns, walks, tennis courts, driveways, or other similar areas.
- Do not use in citrus orchards interplanted to other trees or desirable plants.
- Do not allow dry powder or spray to drift to desirable plants.
- Keep from contact with seeds, insecticides, fungicides, and fertilizers.
- Do not store near well sites.
- Do not graze cattle in treated areas.
- Thoroughly clean all traces of Bromacil/Diuron 40/40 from application equipment immediately after use. Flush tank, pump, hoses, and boom with several changes of water after removing nozzle tips and screens (clean these parts separately).
- Treated areas may be planted to citrus one year after last application.
Do not replant to other crops within two years after last application as injury may result.
IMPORTANT NOTE: Bromacil/Diuron 40/40 use rates listed on the label are for broadcast treatments. For band treatments, use proportionately less.
Follow the application guidelines below:
- Apply using a properly calibrated fixed-boom power sprayer.
- Because over application of the herbicide may result in injury to the crop or successive crops, the spray booms must be shut off while starting, turning, slowing or stopping.
- Use sufficient spray volume, a minimum of 10 gallons per acre, to provide uniform coverage of the treated areas and to allow proper dispersion and suspension of the product in the spray tank.
- Prior to and during application, continuous agitation is necessary to keep the product in suspension. Agitate spray tank contents by mechanical or hydraulic means; do not use air agitation. Note: If a by-pass or return line is used, it should terminate at the bottom of the tank to minimize foaming.
- Nozzle screens should be 50 mesh or larger.
- Best results are obtained if Bromacil/Diuron 40/40 is applied to bare ground. If dense populations of hard-to-kill weed species are present, control of these weeds prior to application of Bromacil/Diuron 40/40 is recommended. If weeds are present at the time of application, tank mixtures with foliar active herbicides are recommended (refer to the Tank Mixture Specific Guidelines section of the label for guidelines on using Bromacil/Diuron 40/40 in a tank mixture).
WEED RESISTANCE TO HERBICIDES
Weeds may become resistant to any herbicide if an herbicide is used in the same field repeatedly over several years. If weed control is unsatisfactory, it may be necessary to retreat the problem area using a product with a different mode of action.
The following suggestions will assist in managing herbicide resistance:
- It may be necessary to change cropping practices within and between crop seasons. For example, using a combination of tillage, retreatment, tank-mixtures and/or sequential herbicide applications that have different modes of action.
- Preventing weeds from going to seed (by mowing, tilling, etc.) will prevent the spread of resistant plants.
- Consult your agricultural dealer, consultant, applicator, and/or appropriate state agricultural extension service representative for specific alternative cultural practices or herbicide recommendations available in your area.
INTEGRATED PEST MANAGEMENT
This product may be used as part of an Integrated Pest Management (IPM) program such as biological, cultural, and genetic practices aimed at preventing economic pest damage. IPM principles and practices include field scouting or other detection methods, correct target pest identification, population monitoring, and treating when target pest populations reach locally determined action thresholds. Consult your state cooperative extension service, professional consultants or other qualified authorities to determine appropriate action treatment threshold levels for treating specific pest/crop systems in your area.
Use best practices to avoid drift to all other crops and non-target areas.
Do not apply when conditions favor drift from target areas. The interaction of many equipment- and weather-related factors determine the potential for spray drift. Avoiding spray drift at the application site is the responsibility of the applicator. The applicator must follow the most restrictive precautions to avoid drift, including those found in the labeling as well as applicable state and local regulations and ordinances. A drift control agent may reduce drift, however, it may also decrease weed control.
Make aerial or ground applications only when the wind speed is less than or equal to 10 miles per hour. Do not make aerial or ground applications into temperature inversions. Apply with medium or coarser spray (according to ASAE standard 572) for standard nozzles.
For ground applications: When applying to crops, apply with nozzle height no more than 2 feet above the ground or crop canopy. When applying to non-crop areas, use the lowest nozzle height consistent with safety and efficacy. Direct spray into target vegetation.
For aerial applications (rights-of-way only): The spray boom should be mounted on the aircraft so as to minimize drift caused by wing tip vortices.
The boom length must not exceed 75% of the wingspan or 90% of rotor blade diameter. Use upwind swath displacement. When applying to rights of way, apply at a minimum safe altitude above the area being treated.
Do not apply by air if sensitive non-target crops are within 100 feet of the application site.
Note: Partial control of perennials usually occurs with a single treatment; repeat applications are required to control perennials. Control of perennials may be improved by cultivation prior to treatment; otherwise, avoid working the soil as long as weed control continues otherwise effectiveness of the treatment may be reduced. Multiple applications may improve control of hard-to-kill weeds.
Refer in the label regarding tank mix information.
Use Restrictions – State of Florida
In Florida, the use of Bromacil/Diuron 40/40 (bromacil + diuron) is prohibited in Hardee, Highland, Polk, Orange and Lake Counties. For Non-Agricultural Usage in all other areas of the state, do not apply more than 16 pounds of Bromacil/Diuron 40/40 per acre per year. This amount corresponds to 6.4 pounds of bromacil and 6.4 pounds of diuron, the active ingredients in Bromacil/Diuron 40/40. The maximum allowable use rate for bromacil is 6.4 pounds per acre per year inclusive of all bromacil formulations.
Instructions for Non-Agricultural Uses of Bromacil/Diuron 40/40 For general weed control in uncultivated non-agricultural areas (for example:
airports, highway, railroad and utility rights-of-way, sewage disposal areas), uncultivated non-crop producing areas (for example: farmyards, fuel storage areas, fence rows, barrier strips) and outdoor industrial sites (for example: lumberyards, pipelines and tank farms).
Combination with other herbicides broadens the spectrum of weeds controlled.
In addition, total vegetation control can be achieved with higher rates of Bromacil/Diuron 40/40 plus residual-type companion herbicides.
To improve the control of emerged weeds, add surfactant at 0.25% by volume.
Do NOT apply this product to:
- Open water (such as creeks, estuaries, lakes, reservoirs, rivers, streams or salt water bays);
- When water is present in fresh water wetlands (such as bogs, marshes, potholes or swamps);
- Saltwater marshes within tidal areas;
- Ditches, banks along waterways or impervious substrates; or,
- Areas near desirable plants where roots of these plants may extend.
Apply Bromacil/Diuron 40/40 using a properly calibrated fixed-boom power sprayer with sufficient spray volume (minimum of 10 gallons per acre) to provide uniform coverage of the treated area and to allow proper dispersion and suspension of the product in the spray tank. All use rates of Bromacil/Diuron 40/40 are expressed for broadcast treatments. For band treatments, use proportionately less.
- Apply a maximum of two applications per year.
- The minimum retreatment interval is 90 days.
- A maximum of 12 pounds active ingredient bromacil per year is allowed.
- A maximum of 12 pounds diuron active ingredient is allowed per year in areas of high rainfall or dense vegetation. A maximum of 8 pounds diuron active ingredient is allowed in all other areas.
Notes for Non-Agricultural Uses:
- For small areas, a hand sprayer or sprinkling may be used. When preparing to a small area, 1/4 cupful of Bromacil/Diuron 40/40 per 200 sq. ft. is approximately 15 pounds per acre.
- Use a spray volume of at least 40 gallons per acre to ensure uniform coverage.
- Do not apply to sites which have roots of desirable plants growing into the treatment zone as plant injury or death may occur.
- Do not apply to hard or impervious soils, water saturated soils or to any surface that does not allow the herbicide to be moved into the soil horizon with moisture. Unusually heavy rainfall shortly after application may move the product off-target to the lowest surrounding point and cause plant injury or death.
- If herbicide treated soil is disturbed by any physical or mechanical means, the herbicide barrier is disrupted and the likelihood of non-performance may increase. For best performance results, make sure the treatment area is stable after the application for the desired weed control period.
Apply Bromacil/Diuron 40/40 as a preemergence spray prior to or during the rainy season when weeds are actively germinating or growing.
Moisture is required to activate and move Bromacil/Diuron 40/40 into the root zone of weeds for preemergence control. For best preemergence weed control, apply prior to rainfall and weed germination.
In arid regions of the Western U.S., to ensure adequate moisture for activation and even dispersion of the herbicide in the soil profile, Bromacil/Diuron 40/40 should be applied several weeks prior to the fall freeze or shortly after spring thaw to coincide with periods of higher seasonal moisture. Do not treat frozen or saturated soils, or soils that are non-receptive to percolation.
Retreatments of Bromacil/Diuron 40/40 may be made when annual weeds and grasses reappear on sites where weed growth has been controlled.
Apply 4-6 pounds of Bromacil/Diuron 40/40 per acre.
Apply a maximum of 2 applications per year. The minimum retreatment interval is 90 days.
Apply Bromacil/Diuron 40/40 at the rates indicated by weed type in the tables below. When applied at lower rates, Bromacil/Diuron 40/40 provides short-term control of the weeds listed; when applied at higher rates, weed control is extended.
Note: Use the higher levels of the dosage ranges listed when applying on adsorptive soils (for example, those high in organic matter or carbon).
For areas of high rainfall or dense vegetation the maximum single application rate is 30 pounds Bromacil/Diuron 40/40 per acre. This amount corresponds to 12 pounds of bromacil and 12 pounds of diuron, the active ingredients in Bromacil/Diuron 40/40. For all other areas, the maximum single application rate is 20 pounds Bromacil/Diuron 40/40 per acre. This amount corresponds to 8 pounds of bromacil and 8 pounds of diuron per acre.
Bromacil/Diuron 40/40 effectively controls the following broadleaf weeds and grasses when applied at the rates shown.
For control of hard-to-kill perennials such as bermudagrass (Cynodon dactylon), bouncingbet (Saporaria officinalis), dogbane (Apocynum spp.), Johnsongrass (Sorghum halepense), and nutsedge (Cyperus spp.) apply 19-30 pounds per acre (except in Florida).
For extended control of annual weeds and partial control of perennials such as bermudagrass and nutsedge, apply 10-18 pounds per acre. In areas of high rainfall (40 inches or more per year) and/or dense vegetation (greater than 90% weed ground cover) apply 19 to 30 pounds of product (except in Florida). Use the higher Bromacil/Diuron 40/40 rates on adsorptive soils (high in organic matter or carbon). Best results occur when application is made just before weed emergence or in the early stages of weed growth.