General Information


CINCH ATZ is a selective herbicide that may be used before planting, before or after emergence (see directions) for control of most annual grasses and broadleaf weeds in corn.

CINCH ATZ can also be used before crop emergence for control of most annual grasses and broadleaf weeds in grain or forage sorghum, provided the sorghum seed has been properly treated by the seed company with “Concep” or “Screen”. This product may be tank mixed with other herbicides specified on the label for weed control in conventional, minimum-till, and no-till corn, grain sorghum, or forage sorghum.

Note: Tank mixtures are permitted only in those states where the tank mix partner is registered. Refer to and follow the label of each tank mix product used for precautionary statements, directions for use, geographic and other restrictions.

When tank-mixing or sequentially applying, atrazine or products containing atrazine to corn or sorghum, the total pounds of atrazine applied (lbs ai/A) must not exceed 2.5 lbs a.i. per year.

Maximum Broadcast Rates for Atrazine

- If no atrazine was applied prior to corn emergence, apply a maximum of 2 lb ai/A broadcast. If a postemergence treatment is required following an earlier herbicide application, the total atrazine applied may not exceed 2.5 lb ai/A per calendar year.

- 2.0 lb ai/A as a single preemergence application on soils that are not highly erodible or on highly erodible if at least 30% of the soil is covered with plant residues, or

- 1.6 lb ai/A as a single preemergence application on highly erodible soils if < 30% of the surface is covered with plant residues, or 2.0 lb ai/A if only applied postemergence.

- If no atrazine was applied prior to corn emergence, apply a maximum of 2 lb ai/A broadcast.

Following many years of continuous use of atrazine (one of the ingredients in CINCH ATZ), and products chemically related to atrazine, biotypes of some of the weeds listed on the label which are controlled by the atrazine component have been reported to develop resistance to this and chemically related herbicides. Where this is known or suspected, and weeds controlled by this product are expected to be present along with resistant biotypes, we recommend the use of CINCH ATZ in combination or in sequence with registered herbicides which do not contain triazines. Consult with your State Agricultural Extension Service for specific recommendations.

Precautions: (1) If sorghum seed is not properly pretreated with “Concep” or “Screen”, DuPont CINCH ATZ will severely injure the crop. (2) Injury may occur to sorghum following the use of CINCH ATZ under abnormally high soil moisture conditions during early development of the crop.

CINCH ATZ alone or in tank mixture with “AAtrex”, “Balance”, CINCH, or “Princep” may be applied early preplant, preplant surface, preplant incorporated, or preemergence on corn, in water or fluid fertilizer. Apply postemergence treatments of CINCH ATZ to corn, alone or in combination, using water only as the carrier. CINCH ATZ may be applied in tank mix combination with “Gramoxone” Inteon , “Landmaster” BW, “Touchdown” or “Roundup UltraMax” (or other formulations of glyphosate) with or without the above herbicides preplant surface or preemergence to corn. CINCH ATZ alone may also be applied on sorghum early preplant, preplant incorporated, preplant surface, or preemergence in water or in fluid fertilizer.

CINCH ATZ may be applied in water by aircraft. Applications in fluid fertilizer should be only by ground equipment.

To avoid spray drift, do not apply under windy conditions.

Avoid spray overlap, as crop injury may result.

Do not apply this product through any type of irrigation system.

Do not apply under conditions which favor runoff or wind erosion of soil containing this product to nontarget areas.

To prevent off-site movement due to runoff or wind erosion:

1. Avoid treating powdery dry or light sand soils when conditions are favorable for wind erosion. Under these conditions, the soil surface should first be settled by rainfall or irrigation.

2. Do not apply to impervious substrates, such as paved or highly compacted surfaces.

3. Do not use tailwater from the first flood or furrow irrigation of treated fields to treat nontarget crops, unless at least ½ inch of rainfall has occurred between application and the first irrigation.

Where reference is made to weeds partially controlled, partial control can either mean erratic control from good to poor or consistent control at a level below that generally considered acceptable for commercial weed control.

Dry weather following preemergence application of CINCH ATZ or a tank mixture may reduce effectiveness. Cultivate if weeds develop in conventional tillage corn or sorghum.

Observe all precautions and limitations on the label of each product used in tank mixtures.

Thoroughly clean sprayer or other application device before using. Dispose of cleaning solution in a responsible manner.

Do not use a sprayer or applicator contaminated with other materials, or crop damage or sprayer clogging of the application device may occur.

Do not apply metolachlor containing products such as “Inter 8E II” herbicide or “Inter Plus II” herbicide in mixture or as sequential applications with CINCH ATZ.

CINCH ATZ Rate Limitations – Corn and Sorghum

Sorghum: Where there are state/local requirements regarding atrazine use (including lower maximum rates and/or greater setbacks) which are different from the label, the more restrictive/protective requirements must be followed. Certain states may have established rate limitations within specific geographical areas. Consult your state lead pesticide control agency for additional information. It is a violation of the label to deviate from state use regulations.

Note: For purposes of calculating total atrazine active ingredient applied, CINCH ATZ contains 3.1 lbs. a.i. atrazine + relateds per gal. (0.775 lb. a.i./qt.).


- On Highly Erodible Land (as defined by the Natural Resource Conservation Service)

If conservation tillage is practiced, leaving at least 30% of the soil covered with plant residues at planting, apply a maximum of 5.2 pt./A as a broadcast spray.

If the soil coverage with plant residue is less than 30% at planting, a maximum of 4.2 pt./A may be applied.

- On Land Not Highly Erodible

Apply a maximum of 5.2 pt./A as a broadcast spray.


If no atrazine was applied prior to corn emergence, apply a maximum of 5.2 pt./A broadcast. If a postemergence treatment is required following an earlier herbicide application, the total atrazine applied may not exceed 2.5 lbs. active ingredient (6.4 pt. of CINCH ATZ) per acre per calendar year.

Limitations, Restrictions, and Exceptions


Preplant Surface, Preplant Incorporated, or Preemergence (Corn or Sorghum-Seed Treated with “Concep” or “Screen”): Apply CINCH ATZ preplant surface, preplant incorporated, or preemergence, using the appropriate rates.

Preplant Surface: Apply uniformly to the soil surface within 14 days before planting. Where applications are made to coarse soils more than 7 days before planting.

Preplant Incorporated: Apply to the soil and incorporate into the top 2 inches of the soil within 14 days before planting, using a finishing disk, finishing harrow, rolling cultivator, or similar implement capable of providing uniform 2-inch incorporation. Use the preplant incorporated method if furrow irrigation is used or when a period of dry weather after application is expected. If crop is to be planted on beds, apply and incorporate after bed formation.

Preemergence: Apply to the soil surface at planting (behind the planter) or after planting, but before weeds or crop emerge.

Notes: (1) In the event of escape of annual weeds following an early preplant, preplant surface, preplant incorporated, or preemergence treatment of CINCH ATZ applied alone or in combination, follow with a postemergence application of an appropriately labeled broadleaf and/or grass weed herbicide, i.e., atrazine, DuPont BASIS, BASIS GOLD, ACCENT, ACCENT GOLD, STEADFAST or dicamba. If the postemergence treatment includes the herbicide used in the earlier treatment, do not exceed the labeled rate for corn on a given soil texture. (2) If “AAtrex” or another product containing atrazine is used postemergence following application of CINCH ATZ, do not exceed a total of 2.5 lbs. a.i./A of atrazine per year. (3) Substitute a fluid fertilizer for some or all of the water carrier for burndown of existing annual weeds listed on the label up to the 2-leaf stage of development. The addition of crop oil concentrate to the spray mixture will enhance the burndown activity. If larger weeds are present, add a contact herbicide as noted in the CINCH ATZ Combinations section of the label.

Control may be improved by following these suggested procedures:

1. In corn, apply up to the maximum single application rate for your given soil texture and rate limitation based on your soil conservation practices.

2. Thoroughly till moist soil to destroy germinating and emerged weeds. If DuPont CINCH ATZ is to be applied preplant incorporated, this tillage may be used to incorporate CINCH ATZ if uniform 2-inch incorporation is achieved as recommended under Application Procedures.

3. Plant crop into moist soil immediately after tillage. If CINCH ATZ is to be used preemergence, apply at planting or immediately after planting.

4. If available, sprinkler irrigate within 2 days after application. Apply 1/2-1 inch of water. Use lower water volume (1/2 inch) on coarse-textured soils and higher volume (1 inch) on fine-textured soils.

5. If irrigation is not possible and rain does not occur within 2 days after planting and application, weed control may be decreased. Under these conditions, a uniform, shallow cultivation should be completed as soon as weeds emerge.

Restricted Entry Interval

24 hours

Exception: If the product is soil-injected or soil-incorporated, the Worker Protection Standard, under certain circumstances, allows workers to enter the treated area if there will be no contact with anything that has been treated.