General Information


For use on plants intended for aesthetic purposes or climatic modifications and being grown in interior plantscapes and on outdoor ornamentals, Christmas trees, nurseries, lawns, sod farms and golf courses.


OnyxPro Insecticide formulation mixes readily with water and other aqueous carriers, and controls a wide spectrum of insects and mites on trees, shrubs, foliage plants, non-bearing fruit and nut trees, and flowers in interiorscapes including hotels, shopping malls, office buildings, etc. and, outdoor plantscapes, such as, but not limited to nurseries, residential dwellings, parks, institutional buildings, recreational areas, athletic fields, golf courses, sod farms and home lawns. Non-bearing crops are perennial crops that will not produce a harvestable raw agricultural commodity during the season of application.

OnyxPro may be tank-mixed with other products, including insect growth regulators. When tank mixing OnyxPro with other products, observe all precautions and limitations on each separate product label. The addition of spreader stickers is not necessary. The physical compatibility of OnyxPro may vary with different sources of pesticide products, and local cultural practices. Any tank mixture which has not been previously tested should be prepared on a small scale (pint or quart jar), using the proper proportions of chemicals and water to ensure the physical compatibility of the mixture.

The following procedure is for preparation of a new tank mix, unless specified otherwise in label directions: (1) Add wettable powders to tank water, (2) Agitate, (3) Add liquids and flowables, (4) Agitate, (5) Add emulsifiable concentrates, and (6) Agitate. If a mixture is found to be incompatible following this order of addition, try reversing the order of addition, or increase the volume of water. Note: If the tank-mixture is found to be compatible after increasing the amount of water, then the sprayer will need to be recalibrated for a higher volume application. Do not allow tank mix to stand overnight. When using tank mixes, observe all restrictions and precautions which appear on the labels of these products. Provide constant agitation to keep the mixture in solution.

Resistance: Some insects are known to develop resistance to products used repeatedly for control. Because the development of resistance cannot be predicted, the use of this product should conform to resistance management strategies established for the use area. Consult your local or state pest management authorities for details.

If resistance to this product develops in your area, this product, or other products with a similar mode of action, may not provide adequate control. If poor performance cannot be attributed to improper application or extreme weather conditions, a resistant strain of insect may be present. If you experience difficulty with control and suspect that resistance is a reasonable cause, immediately consult your local company representative or pest management advisor for the best alternative method of control for your area.


Do not apply to pets, crops, or sources of electricity.

Firewood is not to be treated.

Do not allow spray to contact food, foodstuffs, food contacting surfaces, food utensils or water supplies.

Do not apply this pesticide in livestock buildings (barns).

Keep children and pets off treated areas following application until the spray has dried.

Do not apply by air.

Do not use in greenhouses.

Do not apply this product through any type of irrigation system.

Do not apply when a temperature inversion exists.

Do not apply for surface feeding pests if rain is expected within 12 hours (or what ever time is necessary for the spray to dry).

For turf treatment, apply with nozzles not more than 2 feet above the grass.

Do not apply within 25 feet of lakes, reservoirs, rivers, permanent streams, marshes or natural ponds, estuaries and commercial fish farm ponds.

Do not apply when grass areas are water logged or the soil is saturated with water (i.e. will not accept irrigation).

Limitations, Restrictions, and Exceptions


Fungus Gnat Larval Control - Curative Treatment - Topical Drench:

To control fungus gnat larvae infesting containerized plants, dilute OnyxPro Insecticide at the rate of 3.6 to 14.4 fl. ozs. (0.05 to 0.2 lb AI) per 100 gallons and apply as a drench at the rate of 8 to 16 fluid ounces of finished spray per 6 inch (diameter) container. Use a proportional volume of finished spray for containers less than or greater than 6 inches in diameter. Ideally, the media should be treated to the point of saturation, which generally requires 1/5 the volume of the container.

Restricted Entry Interval

12 hours