DORMANT NONBEARING GRAPE PLANTINGS - PREEMERGENCE

General Information

GENERAL USE INFORMATION

Unless otherwise directed by registered supplemental labels, follow the Directions for Use in each crop group section.

IMPORTANT: Read the entire DIRECTIONS FOR USE and the LIMITATION OF WARRANTY AND LIABILITY before using this product. If terms are not acceptable, return the unopened product container to the place of purchase at once.

When an adjuvant is to be used with this product, Makhteshim Agan of North America, Inc. suggests the use of a Chemical Producers and Distributors Association certified adjuvant.

IMPORTANT: TREATED SOIL MUST BE THOROUGHLY INCORPORATED TO A DEPTH OF 4 INCHES AFTER HARVEST (OR ABANDONING) OF THE TREATED CROP BUT PRIOR TO PLANTING OF THE ROTATIONAL CROP. FAILURE TO ACHIEVE THIS THOROUGH AND COMPLETE INCORPORATION OR TO FOLLOW THE REQUIRED MINIMUM PLANT-BACK INTERVAL MAY RESULT IN CROP INJURY, STAND REDUCTION, AND/OR VIGOR REDUCTION OF THE PLANT-BACK CROP. See specific fallow bed labeling regarding crop planting information for applications of GALIGAN 2E made to a fallow bed or fallow field.

GENERAL USE RESTRICTIONS

USE RESTRICTIONS THAT APPLY TO ALL REGISTERED APPLICATIONS ARE LISTED BELOW:

- Read and observe all label directions before using. When tank mixing, always read all individual manufacturers' labels. In interpreting all labels for the tank mixture, the most restrictive situations must apply.

- Do not contaminate irrigation water or water used for domestic purposes.

- Do not use any plants treated with GALIGAN 2E herbicide for feed or forage.

- Do not feed or allow animals to graze on any areas treated with GALIGAN 2E herbicide.

- GALIGAN 2E herbicide should be applied only by ground application equipment except as specifically directed on the label or on other approved supplemental labeling.

- Do not apply when weather conditions favor drift. Avoid drift to all nontarget areas. GALIGAN 2E herbicide is phytotoxic to plant foliage.

- Thoroughly flush spray equipment (tank, pump, hoses, and boom) with clean water before and after each use. Residual GALIGAN 2E herbicide remaining in spray equipment may damage other crops. To assist in the removal of GALIGAN 2E herbicide residues in spray equipment, a non-ionic surfactant such as Latron AG-98 or Latron CS-7 may be added at the rate of 1 quart per 100 gallons of water during flushing.

- Use GALIGAN 2E herbicide only for recommended purposes and at recommended rates.

- Do not treat ditch banks or waterways with GALIGAN 2E herbicide.

- On all labeled food and/or feed crops, the maximum seasonal application rate is 1.5 lbs. active ingredient (6 pints of this product) per acre (except tropical commodities grown in Hawaii).

- On all labeled ornamentals, the maximum application rate of 1.5 lbs. active ingredient (6 pints of this product) per application is allowed. A total of 4.5 lbs. active ingredient (18 pints of this product) is allowed per season.

- On all labeled conifer seedlings, the maximum application rate is 2 lbs. active ingredient (8 pints of this product) per acre.

Refer to the label regarding chemigation and tank mix information.

Limitations, Restrictions, and Exceptions

TIMING

Applications of Galigan 2E herbicide should not be made after budswell. In the fall, Galigan 2E herbicide can be applied after the grape plantings are dormant or frost has occurred. Applications prior to dormancy or frost occurring may result in significant crop injury and are the responsibility of the user.

Apply Galigan 2E herbicide to dormant vines, prior to budswell. The closer the grapes are to bud-break at application, the greater the crop response can be to Galigan 2E herbicide. Do not apply Galigan 2E herbicide after buds start to swell.

METHOD OF APPLICATION

Apply a minimum of 40 gallons of water per acre. Use higher volumes to ensure adequate coverage in high densities of emerged weeds or heavy trash. Best preemergence results are achieved when spray is applied to a relatively weed-free established berm or soil surface. Galigan 2E herbicide may be applied as an over-the-top or directed spray to dormant nonbearing grape plantings. The use of a low-pressure sprayer is suggested.

Method
Restricted Entry Interval

24 hours