VEGETABLES - SOIL APPLICATION - CAULIFLOWER
Whirlwind is an emulsifiable concentrate for use in listed crops. Target pests and application rates are provided in the accompanying tables.
The label booklet is not valid for use of this product in the state of Mississippi. For use in the state of Mississippi, refer to Whirlwind supplemental labeling entitled “Use Directions for the State of Mississippi.”
General Use Precautions
Insect control may be reduced at low spray volumes under high temperature and wind conditions.
Some reduction in insect control may occur under unusually cool conditions.
Flood irrigation: To avoid contamination of irrigation tail waters, do not flood irrigate within 24 hours following a soil surface or foliar application of Whirlwind.
BROADCAST FOLIAR APPLICATION
Apply with conventional power-operated spray equipment using nozzles and spray pressures recommended for insecticides. Apply Whirlwind in a spray volume of not less than 2 gallons per acre for aerial application equipment (fixed-wing or helicopter) or not less than 10 gallons per acre for ground equipment, unless otherwise specified. Increase spray volume to ensure adequate coverage with increased density and height of crop canopy. See Spray Drift Precautions section for recommendations on droplet size.
GROUND APPLICATION: Orient the boom and nozzles so that uniform coverage is obtained. The swath width should not be wider than the boom. Follow nozzle manufacturer’s recommendations for insecticide nozzles with respect to nozzle type, pressure, and spacing.
BROADCAST SOIL APPLICATION
Apply with conventional power-operated spray equipment that will apply the product uniformly to the soil surface. Use nozzles that produce medium or coarse droplets (235-400 microns). Unless otherwise indicated, a spray volume of 10 gallons or more per acre is recommended. For band application, use proportionally less spray volume.
Use a minimum spray volume of 2 gallons per acre and follow recommendations for best management practices for aerial application, above.
Marking of swaths by flagging, permanent markers or use of GPS equipment is recommended.
CHEMIGATION (SPRINKLER IRRIGATION)
Whirlwind may be applied to the following crops through sprinkler irrigation equipment: alfalfa, almond (orchard floors only), citrus (orchard floors only), corn (field and sweet), cotton, cranberry, mint, sorghum, soybeans, sugarbeet, orchard floors (pecan and walnut), walnut (orchard floors only), and wheat, or other crops as specified in supplemental labeling. Do not apply this product by chemigation unless specified in crop-specific directions in the label or Dow AgroSciences supplemental labeling. Do not apply to labeled crops through any other type of irrigation system.
Note: Unless otherwise indicated in specific use directions, the application rates for chemigation are the same as those recommended for broadcast application.
Special Use Directions for Sprinkler Irrigation
The following use directions must be followed when Whirlwind is applied through sprinkler irrigation systems. Thoroughly clean the injection system and tank of any fertilizer or chemical residues, and dispose of the residues according to state and federal laws. Flush the injector with soap and water. Determine the amount of Whirlwind needed to cover the desired acreage. Mix according to instructions in the Mixing Directions section and bring mixture to desired volume. Do not add crop oil when Whirlwind is applied by chemigation. Maintain continuous agitation during mixing and throughout the application period. Set the sprinkler system to deliver the desired inches of water per acre. Start the water pump and sprinkler, and let the system achieve the desired pressure and speed before starting the injector. Start the injector and calibrate the injector system according to Calibration instructions in the following Special Use Precautions section. The mixture containing Whirlwind must be injected continuously and uniformly into the irrigation water line as the sprinkler is moving to ensure uniform application at the correct rate. When the application is finished, flush and clean the entire irrigation and injector system prior to shutting down the system.
Apply as indicated in Pest-Specific Use Directions. Use a higher rate in the rate range when there is increased pest pressure.
Pest-Specific Use Directions:
1. Root maggot:
- Direct seeded crops (Cauliflower, Broccoli, Brussels Sprout, Cabbage, Chinese Cabbage, Collard, Kale, Kohlrabi, Turnip, Rutabaga): Apply the specified dosage in a water-based spray as a 4-inch wide band over the row at planting time. Band placement should be behind the planter shoe and in front of the press wheel to achieve shallow incorporation. Use a minimum of 40 gpa total spray volume.
- Transplanted crops (Cauliflower, Broccoli, Brussels Sprout, Cabbage, Chinese Cabbage, Collards, Kale, Kohlrabi, and Turnips): Apply Whirlwind as a water-based spray directed to the base of the plants immediately after setting. Use a minimum of 40 gpa total spray. Do not add any additional adjuvants, surfactants or spreader stickers. Do not apply as a foliage application.
Specific Use Restrictions:
- Cauliflower: Do not apply more than 2 pints of Whirlwind to cauliflower planted in 40-inch rows. Use proportional amounts for other row spacings, but do not exceed 4 pints per acre of Whirlwind. Do not make more than 1 soil application per crop.
- Soil applications (all labeled crops): Do not foliar apply any chlorpyrifos product labeled for foliar application (e.g., Lorsban 50W) within 10 days of a soil application of Whirlwind