General Information


REVOKE is an effective contact insecticide, miticide and fungicide for control of soft bodied insects, mites and powdery mildew. This product may be used to control targeted pests on crops which include vegetables, grapes and other small fruits, tree fruits, tree nuts, cotton, tobacco, shrubs, shade and ornamental trees, turf, foliage and flowering plants growing outdoors, in greenhouses and in interiorscapes.

This product can be applied up to harvest.

Pests Controlled

This product may be used as a foliar spray to control or suppress soft bodied pests which include:

adelgids, aphids, caterpillars, earwigs, lace bugs, leafhoppers, leafminers, mealybugs, mole crickets, plant bugs, psyllids, sawfly larvae, scales, spider mites, tent caterpillar, thrips, whiteflies, gypsy moth, and chinch bugs. This product provides curative control of powdery mildew.



Stand-alone rate: REVOKE rates as low a 0.25% v/v or as high as 4% v/v may be used. The 2%

v/v is the most frequently used stand-alone rate.

Refer to individual sections of the label for specific use rates for control of pests on specific crops.

Rates are provided as a % volume/volume (v/v) solution. A 2% v/v solution is prepared by adding 2 gallons of REVOKE to 98 gallons of spray water.

The activity of this product is directly related to the solution concentration and to contact with the pest, not to the amount of product applied per acre.

Tank-mix rate: To achieve enhanced and residual pest control, use a 1 to 2 % v/v solution of this

product in combination with a recommended product.

Timing of Application

Initiate applications as soon as pest is observed, or as needed to avoid economic injury. Repeat applications at one to two week intervals, or as needed, to control reinfesting or increasing pest populations.

Do not make repeat applications at less than 7 day intervals, or make more than 3 sequential applications at 7 to 14 day intervals unless your prior experience has shown the use pattern to be

non-injurious to the type and the developmental stage of plant(s) to be treated under local growing conditions.

Application Guidelines

This product may be applied with most types of ground or aerial spray equipment. Do not use with pulse or thermal fogger applicators. Do not apply through any type of irrigation system.

This product must come into contact with the targeted soft bodied pests or powdery mildew to be

effective. Complete coverage of pests is essential for maximum control. Direct sprays to contact

the pests. In general, adequate coverage requires a minimum of 50 gallons of total spray volume

per acre. Higher volumes may be required on larger perennial crops.

Apply REVOKE solutions to wet (minimize run-off) to decrease the potential for injury on foliage,

fruit and flowers of sensitive plants.

Apply promptly after mixing with other pesticides to avoid or reduce alkaline hydrolysis of certain


Avoid applications when wind conditions impair thorough coverage.

Avoid applications on new transplants and unrooted cuttings.

Limitations, Restrictions, and Exceptions


Application Instructions:

Stand-alone rate: Apply a 1-2% v/v solution of this product, unless otherwise noted. Refer to the MIXING AND APPLICATION section of the label for general rate, timing and application information except as noted.

Tank-mix rate: To achieve enhanced and residual pest control, use a 1 to 2 % v/v solution of this product in combination with a recommended product. Tank mixes with products containing Chlorothalonil should be avoided as they can cause severe phytotoxicity. Lower rates (0.25 to 1.0 % v/v solution) of this product may be used in tank-mixes for knockdown/suppression of adult whiteflies.

Note: Unless otherwise noted, apply this product to wet (minimize run off). If wilting occurs a few hours after application, rinse with a clean water spray. Since applications may cause injury to flowers of some plant cultivars, test product on a few flowering plants under local use conditions prior to large scale use.

Pest: Apply 1-2% solution of this product to thoroughly wet infested needles. Repeat application after 7 days if needed.

Restricted Entry Interval

12 hours