CROP STUBBLE AND FALLOW LAND - PERENNIAL BROADLEAF
Performance of this product may be affected by local condition, crop varieties, and application method. User should consult local extension service, agricultural experiment, or university weed specialists, and State regulatory agencies for recommendations in your area.
Best results are obtained when product is applied to young succulent weeds that are actively growing. Application rates lower than recommended will be satisfactory on susceptible annual weeds. For perennial weeds and conditions such as the very dry areas of the western states, where control is difficult, the higher recommended rates should be used. When product is used for weed control in crops, the growth stage of the crop must be considered.
Some plants and weeds, especially woody varieties, are difficult to control and may require repeat applications. Application rates should be 1 to 5 gallons of total spray by air or 5 to 25 gallons by ground equipment unless otherwise directed. In either case, use the same amount of 2,4-D recommended per acre. For crop uses, do not mix with oil, surfactants, or other adjuvants unless specifically recommended on label. To do so may reduce herbicide’s selectivity and could result in crop damage.
Aerial application should be used only when there is no danger of drift to susceptible crops. Many states have regulations concerning aerial application of 2,4-D formulations. Consult local regulatory authorities before making applications. This product contains the Dimethylamine salt of 2,4-D, one of the least volatile forms of 2,4-D.
Because coarse sprays are less likely to drift than fine, do not use equipment (such as hollow cone small-orifice nozzles) or conditions (such as high pressure) that produce such sprays.
Product should not be allowed to come into contact with desirable, susceptible plants such as beans, cotton, fruit trees, grapes, legumes, ornamentals, peas, tomatoes, and other vegetables. Product should not be used in greenhouses. Excessive amounts of this product in the soil may temporarily inhibit seed germination and all plant growth.
Users should note that herbicide treatment of public water requires a permit from appropriate state agencies in most states. Your State Conservation Department, or Game and Fish Commission will aid you in securing a permit in your state. If stored below freezing, it may be necessary to warm product to 70°F and agitate before using. This does not affect the efficiency of the product.
Spray equipment used to apply 2,4-D should not be used for any other purpose until thoroughly cleaned with suitable chemical cleaner containing ammonia.
Spray Preparation: Add the recommended amount of OPTI-AMINE to approximately one-half the volume of water to be used for spraying. Agitate well, and then add the remainder of the water. Continue agitation during application until spray tank is empty.
Use in Liquid Nitrogen Fertilizer: OPTI-AMINE may be combined with liquid nitrogen fertilizer suitable for foliar application of corn, grass, pastures, or small grains in one operation. Use OPTI-AMINE according to directions on the label for those crops. Use liquid nitrogen fertilizer at rates recommended by supplier or extension service specialist.
NOTE: Pre-mixing the product with an equal amount of water is important.
CROP STUBBLE AND FALLOW LAND:
Spray weed in the bud to bloom stage or while in good vegetative growth. Do not disturb treated areas for at least 2 weeks after treatment, or until tops are dead.
RESTRICTIONS AND LIMITATIONS FOR USE IN FALLOWLAND (CROP STUBBLE ON IDLE LAND OR POST-HARVEST TO CROPS OR BETWEEN CROPS):
- Only labeled crops can be planted within 30 days after application.
- Limited to 2 applications per year.
- Minimum of 30 days between applications.