SUNFLOWER - ARMYWORM AND SPIDER MITES

General Information

GENERAL DIRECTIONS FOR USE

Initial and residual control are contingent upon thorough crop coverage. Apply with ground or air equipment using sufficient water to obtain full coverage of foliage. Apply in a minimum of 2 gals./A by air or 10 gals./A by ground unless otherwise specified in the label. When foliage is dense or pest pressure is high (heavier insect or egg pressure, larger larval stages), use of higher application volumes and/or higher use-rates may improve initial and residual control.

For cutworm control, LAMBDA T may be applied before, during, or after planting. For soil incorporated applications, use higher rates for improved control.

Limitations, Restrictions, and Exceptions

SUNFLOWER

- Apply as required by scouting, usually at intervals of 5 or more days. Timing and frequency of applications should be based upon insect populations reaching locally-determined economic thresholds.

- Apply with ground or air equipment using sufficient water to obtain full coverage of sunflower heads and/or foliage. When applying by air, apply in a minimum of 2 gals. of water/A.

- Do not apply more than 0.09 lb. a.i. (0.72 pts.)/A per season after bloom initiation.

- Do not apply as an ultra-low-volume (ULV) spray.

Target pest:

Beet Armyworm and Spider Mite species: Suppression only.

Beet Armyworm: See resistance statement under General Directions for Use.

Pre-Harvest Interval

45 days

Restricted Entry Interval

24 hours

The material and content contained in the Greenbook label database is for general use information only. Agworld and Greenbook do not provide any guarantee or assurance that the information obtained through this service is accurate, current or correct, and are therefore not liable for any loss resulting, directly or indirectly, from reliance upon this service. This label database does not replace the official manufacture issued label. Users of this database must read and follow the actual product label affixed to the container before use of the product.