CORN - POSTEMERGENCE APPLICATIONS
Marksman herbicide is a water-dispersible formulation for use in corn, sorghum, or fallow to control annual broadleaf weeds and to suppress perennial broadleaf weeds.
Mode of Action
Marksman contains two active ingredients: dicamba and atrazine. Dicamba is readily absorbed by plants through shoot and root uptake, translocates throughout the plant’s system, and accumulates in areas of active growth. Dicamba interferes with the plant’s growth hormones (auxins) resulting in death of many broadleaf weeds. Atrazine is absorbed by roots and shoots and controls weeds by inhibiting photosynthesis.
Dicamba has a low probability of selecting for resistant biotypes. With repeated use, atrazine has selected for resistant biotypes of some weed species. Combining the two herbicides, which are each active in a similar broadleaf weed spectrum, reduces the risk of selecting for resistant biotypes.
Marksman herbicide can be applied pre-emergence or postemergence to actively growing weeds as aerial, broadcast, band, or spot spray applications using water or sprayable fertilizer as a carrier. Sprayable fluid fertilizer as a carrier is not recommended for use after crop emergence. For crop-specific application timing and other details, refer to section VI. Crop-Specific Information.
To avoid uneven spray coverage, Marksmanshould not be applied during periods of gusty wind or when wind is in excess of 15 mph.
Avoid off-target movement. Use extreme care when applying Marksman to prevent injury to desirable plants and shrubs.
Sensitive Crop Precautions
Marksman may cause injury to desirable trees and plants, particularly beans, cotton, flowers, fruit trees, grapes, ornamentals, peas, potatoes, soybeans, sunflowers, tobacco, tomatoes, and other broadleaf plants when contacting their roots, stems, or foliage. These plants are most sensitive to Marksman during their development or growing stage.
Water Volume: Use 2-10 gallons of water per acre. Use the higher spray volume when treating dense or tall vegetation.
Application Equipment: Select nozzles designed to produce minimal amounts of fine spray particles. Make applications at the lowest safe height to reduce the exposure of spray droplets to evaporation and wind.
Ground Application (Banding)
When applying Marksman herbicide by banding, determine the amount of herbicide and water volume needed.
Ground Application (Broadcast)
Water Volume: Use 10-50 gallons of spray solution per broadcast acre for optimal performance. Use the higher spray volume when treating dense or tall vegetation.
Application Equipment: Select nozzles designed to produce minimal amounts of fine spray particles. Spray with nozzles as close to the weeds as is practical for good weed coverage.
Corn (Field, Pop, Seed, and Silage)
Corn may be harvested or grazed for feed after it has reached the ensilage (milk) stage or later in maturity.
Direct contact of Marksman herbicide with corn seed must be avoided in preplant or pre-emergence applications. If corn seeds are less than 1.5\" below the soil surface, delay application until corn has emerged.
Do not apply Marksman to seed corn or popcorn without first verifying with your local seed corn company (supplier) the selectivity of Marksman on your inbred line or variety of popcorn. This precaution will help avoid potential injury of sensitive varieties.
Marksman is not registered for use on sweet corn.
Avoid using crop oil concentrates after crop emergence as crop injury may result. Use crop oil concentrates only in dry conditions when corn is less than 5\" tall and when applying Marksman alone or tank mixed with atrazine.
For field corn forage uses, a 60-day PHI is required.
Postemergence applications to corn must be made before crop reaches 12 inches in height.
Maximum broadcast application rates for corn must be as follows:
- If no atrazine was applied prior to corn emergence, apply a maximum of 2.0 lbs. of atrazine a.i./A broadcast. If postemergence treatment is required following an earlier herbicide application, the total atrazine applied may not exceed 2.5 lbs. a.i./A per calender year.
- Apply a maximum of 2.0 lbs. of atrazine a.i./A as a single preemergence application on soils that are not highly erodible or on highly erodible soils (as defined by the Natural Resource Conservation Service) if at least 30% of the surface is covered with plant residues; or
- Apply a maximum of 1.6 lbs. of atrazine a.i./A as a single preemergence application on highly erodible soils (as defined by the Natural Resource Conservation Service) if <30% of the surface is covered with plant residues; or 2.0 lbs. of atrazine a.i./A if only applied postemergence.
EARLY POSTEMERGENCE APPLICATION IN ALL TILLAGE SYSTEMS:
Reduce the rate to 2 pints per treated acre for corn grown on coarse-textured soils (sand, loamy sand, and sandy loam).
Apply between corn emergence and the 5-leaf stage or 8\" tall, whichever occurs first.