NON-CROP

General Information

GENERAL INFORMATION

This product is a herbicide for use in cotton, non-bearing fruit and nut trees, bearing and non-bearing citrus, bluegrass, fescue and ryegrass grown for seed, in forestry and on non-crop areas. This product does not contain a surfactant. A suitable non-ionic surfactant approved for growing crops covered by the label should be added to the spray tank. Local conditions and recommendations vary; consult local agricultural experiment station or extension service weed specialists for recommendations in your area.

Limitations, Restrictions, and Exceptions

NON-CROP:

This product is effective in control of the above listed weeds and many similar weeds on drainage ditch banks, rightsof- way (including highway, railroad, pipeline, and utility), fence rows, golf course sand traps, storage yards and many similar noncrop areas. Application should be made when weeds are small and conditions are favorable for good weed growth. Mix at a rate of 2 1/2 to 6 pints of this product, plus manufacturer’s recommended rate of a suitable surfactant, in 40 to 50 gallons of water for application to one acre. DO NOT apply more than 5 lbs. a.i. (6 pints) of this product per acre per application. Use higher rates and spray volume for dense weed growth. For small areas, use 1 to 2 fluid ounces in 5 gallons per 1,000 square feet. Spray undesirable vegetation thoroughly to point of runoff. Adequate coverage and complete wetting of foliage is important for effective control. Repeat applications may be necessary if regrowth occurs. DO NOT make more than five (5) applications per year. Use only as spot treatment in Florida.

Method
Restricted Entry Interval

12 hours