General Information


This product is a herbicide for use in cotton, non-bearing fruit and nut trees, bearing and non-bearing citrus, bluegrass, fescue and ryegrass grown for seed, in forestry and on non-crop areas. This product does not contain a surfactant. A suitable non-ionic surfactant approved for growing crops covered by the label should be added to the spray tank. Local conditions and recommendations vary; consult local agricultural experiment station or extension service weed specialists for recommendations in your area.

Limitations, Restrictions, and Exceptions

POSTEMERGENT DIRECTED SPRAY APPLICATION ON COTTON when weeds are small using ground equipment. Mix this product at the rate of 2 2/3 pints in 40 gallons of water per acre. For band applications, apply 1 gallon in 40 gallons of water per acre. For band applications, apply 1 gallon of above diluted spray per acre for each 1 inch band width to be treated of cotton grown on 40 inch row spacing. DO NOT apply more than 2.0 lbs. a.i. (2 2/3 pints) of this product per acre per application. A second or repeat application, if needed, should be timed about 1 to 3 weeks after the first application. Keep spray off cotton foliage. Apply only when cotton is 3 inches high to first bloom. Do not apply after first bloom. DO NOT make more than two (2) applications total of either DSMA or MSMA (or a combination) per season.

Special precautions: DO NOT allow spray or spray drift to contact adjacent crops or injury will result. Apply only on still days when weather conditions DO NOT favor drift from areas being treated. Aircraft applications of this product should only be made by applicators experienced in use of herbicides, and application should be made in accordance with State and Federal regulations.

Note: Applications to cotton in Florida should be confined to band treatments.

Restricted Entry Interval

12 hours