CUCURBIT CROPS - PRE-PLANT SEEDLING NURSERY APPLICATION

General Information

GENERAL APPLICATION INSTRUCTIONS

Apply this product by various application methods, including foliar spray (aerial and ground), soil drench, soil incorporation and bare root dip. For foliar sprays, apply this product with sufficient water volumes for adequate coverage of foliage, according to crop and growth stage.

Make applications prior to disease development in conjunction with good cultural management practices. Do not exceed the use rates or apply more frequently than the specified interval or plant injury can occur. Do not apply to plants that are dormant or heat or moisture stressed. To avoid undesirable copper phytotoxicity, do not make foliar applications to plants treated with copper-based compounds at less than 20 day intervals unless instructed to do so by your crop consultant. Allow foliage to dry completely after application. Do not apply when conditions favor wet tissue for prolonged periods (>4 hours).

See label for tank mix information.

Limitations, Restrictions, and Exceptions

CUCURBIT CROPS

Disease Prevention/Low Pressure

Program: Apply lower rate at 1-2 week intervals.

Disease Control/High Pressure

Program: Apply higher rate at 7-10 day intervals.

Pre-plant Seedling Nursery application: Apply 1 qt/100 gallons water to nursery plants in seedling trays 1-7 days prior to out planting.

Method
Restricted Entry Interval

4 hours

Timings

The material and content contained in the Greenbook label database is for general use information only. Agworld and Greenbook do not provide any guarantee or assurance that the information obtained through this service is accurate, current or correct, and are therefore not liable for any loss resulting, directly or indirectly, from reliance upon this service. This label database does not replace the official manufacture issued label. Users of this database must read and follow the actual product label affixed to the container before use of the product.