GENERAL HYDROPONIC APPLICATION

General Information

GENERAL APPLICATION INSTRUCTIONS

Apply this product by various application methods, including foliar spray (aerial and ground), soil drench, soil incorporation and bare root dip. For foliar sprays, apply this product with sufficient water volumes for adequate coverage of foliage, according to crop and growth stage.

Make applications prior to disease development in conjunction with good cultural management practices. Do not exceed the use rates or apply more frequently than the specified interval or plant injury can occur. Do not apply to plants that are dormant or heat or moisture stressed. To avoid undesirable copper phytotoxicity, do not make foliar applications to plants treated with copper-based compounds at less than 20 day intervals unless instructed to do so by your crop consultant. Allow foliage to dry completely after application. Do not apply when conditions favor wet tissue for prolonged periods (>4 hours).

See label for tank mix information.

Limitations, Restrictions, and Exceptions

GENERAL HYDROPONIC APPLICATION

Not for use in California unless accompanied by a supplemental label.

Add 1-2 liters Fungi-Phite per 20,000 L nutrient solution.

For use with plants grown in recirculating hydroponic systems to aid in the control of pathogens.

Repeat every 4-6 weeks in summer and every eight weeks in winter.

Depending on crop load and the water quality, the application time interval may be reduced.

Note: For Recirculating (i.e. closed systems) use only. Do not remove reservoir water prior to harvest. Apply solid residue as fertilizer only at Fungi-Phite concentrations at or below those approved on the label for direct application.

Method
Restricted Entry Interval

4 hours

Timings