BEDDING PLANTS (BEGONIA, PANSY, ETC.) - FOLIAR
DIRECTIONS FOR USE
This product is not to be used on home or residential sites.
Quali-Pro Fosetyl-Al 80 WDG is a systemic fungicide that, when used according to the label directions and as part of good management practices programs, will control or suppress listed fungal diseases in a variety of crops.
Although Quali-Pro Fosetyl-Al 80 WDG has been found to be safe to use with the species listed on the label, it is impossible to test all species or varieties under all types of growing conditions for tolerance to Quali-Pro Fosetyl-Al 80 WDG. Always test for plant phytotoxicity on a small scale using the recommended rates before preparing spray solutions or applying to large areas of plants.
APPLICATION DIRECTIONS FOR FOLIAR SPRAYS
For systemic control of various fungal diseases, apply Quali-Pro Fosetyl-Al 80 WDG according to these label directions.
Apply Quali-Pro Fosetyl-Al 80 WDG in a sufficient amount of water to ensure thorough coverage of plant foliage. The spray volumes will vary by crop and growth stage.
APPLICATION DIRECTIONS FOR SPRINKLER IRRIGATION SYSTEMS
Do not apply Quali-Pro Fosetyl-Al 80 WDG through chemigation in California.
Apply this product only through sprinkler irrigation systems including mini-sprinkler or micro-jet, drip, solid set, and center pivot. Do not apply this product through any other type of irrigation system.
A suspension of Quali-Pro Fosetyl-Al 80 WDG is prepared in a mixing tank by adding 1/2 to 3/4 of the desired amount of water. Start the agitator and then add the required amount of Quali-Pro Fosetyl-Al 80 WDG followed by the remaining volume of water. Then set sprinkler to deliver 0.1 to 0.3 inch of water per acre. Start sprinkler and uniformly inject the suspension of Quali-Pro Fosetyl-Al 80 WDG into the irrigation water line to deliver the desired rate per acre. The suspension should be injected with a positive displacement pump into the main line ahead of a right angle turn to insure adequate mixing. If you should have any other questions about calibration, you should contact State Extension Service specialists, equipment manufacturers, or other experts.
Refer in the label for tank mix information.
Apply Quali-Pro Fosetyl-Al 80 WDG to wet the foliage. Do not exceed 400 gals. of spray solution per acre. Make repeat applications as needed but not more often than every 14 days.