General Information

General Information

BRANDT STERIC S is a liquid plant food especially formulated to
promote uptake for correction of sulfur deficiencies. It quickly
boosts plant growth during critical or high growth periods
and can help reduce stress due to weather. This product is
recommended for use on, but not limited to, vegetable and
row crops, deciduous fruit and nut trees, citrus, avocados, vine
and berry crops, ornamentals, turf, pasture and range grasses.

Mixing and Handling Instructions

Compatibility: This product may be applied separately or in
conjunction with most other fertilizers. It is compatible with
most acid based fertilizers and other plant nutrients. However,
a compatibility test is recommended if the desired combination
has not been previously used.
DO NOT mix with ammonium thiosulfate, potassium thiosulfate
or other high pH or high free-ammonia products. When
mixing this product with UAN 32, it is suggested to use up to
one gallon of water per one gallon of UAN 32 to insure complete
and thorough mixing. This product is a low pH material
and should only be applied with suitable equipment.

Application Method: This product is most effective when applied
through an irrigation system or banded. Soil applications can be
incorporated in liquid fertilizer or applied separately. Accurate
and properly calibrated injection equipment and an irrigation
system that is operated at maximum distribution uniformity will help avoid plant injury and/or product ineffectiveness. For best
results, with the exception of center pivot and lateral systems,
apply this product toward the end of the irrigation set. Allow
sufficient time for the product to be flushed completely out of
the irrigation system prior to turning off the irrigation water.

Mixing: Add this product to a partially filled tank and slowly
add the remaining water while maintaining constant agitation.
Always add this product to the spray tank before adding other
agricultural chemicals. To avoid potential phytotoxicity, test a
small amount of solution on the intended target area to ensure
plant compatibility prior to the planned application.

Limitations, Restrictions, and Exceptions

In the absence of a soil or leaf analysis to determine sulfur deficiency, apply the following rates:
Mild Deficiency . . . . . . . . . . . . . . . . . . . . . . . . 2-5 gallons/acre
After initial application, monitor plant nutrient levels and apply again as needed.