SWEET CORN (GRAIN AND SILAGE), SWEET CORN GROWN FOR SEED (AT PLANT USE) - ARMY CUTWORM, CUTWORM, ETC.

General Information

RESISTANCE

Repeated use of certain insecticides may create resistance in some target pests, resulting in a decrease of control. Bifenthrin 2EC AG should be used in accordance with treatment area-appropriate strategies for resistance management. For further information regarding resistance management strategies for your treatment area, consult local or state pest management authorities.

If you are unable to attain adequate control of a target pest and this loss of control cannot be explained by misapplication or weather extremes, it is possible that resistance has developed within the target population. If this appears to have occurred, promptly seek advice from your pest management advisor or company representation regarding alternative control techniques.

APPLICATION INSTRUCTIONS

The timing of application, infestation levels and field scouting will impact what application rate should be used:

For Light – Moderate Pest Pressure: use lower rates.

For Mite Control, Heavy Pest Pressure or applications in arid climates: use higher rates.

To prevent unwanted exposure to bodies of water, maintain a 10 foot-wide non-cultivated vegetative strip filter.

In New York State this product may not be applied within 100 feet (using ground equipment) to 300 feet (using aerial equipment) of coastal marshes or streams that drain into coastal marshes.

Limitations, Restrictions, and Exceptions

SWEET CORN (GRAIN AND SILAGE), SWEET CORN GROWN FOR SEED (AT PLANT USE)

T-Band Treatment: Over open seed furrow, make an application in a 5 to 7 inch T-band. The spray nozzle must be placed behind the planter shoe, ahead of the press wheel and centered over the row. The table below will assist you in determining the appropriate BIFENTHRIN 2EC AG requirements per acre. The specified dosage must be applied in no less than 3 gallons of finished spray per acre.

In order to mix BIFENTHRIN 2EC AG with water or fertilizer, follow the following steps:

The spray tank should be filled half-way with water or liquid fertilizer. Mix in the correct amount of BIFENTHRIN 2EC AG. Add the remaining water or fertilizer. Mix thoroughly via agitation to create and maintain a uniform spray mixture.

You may use applications of BIFENTHRIN 2EC AG by itself or in recommended tank mixtures. You may also use applications of BIFENTHRIN 2EC AG in conjunction with in furrow pop-up fertilizers. In order to ensure that the mixture will remain in solution, you should perform a jar compatibility test using the correct ratio of BIFENTHRIN 2EC AG and fertilizer. During mixing and application, constant agitation is necessary.

Do not apply this product to soil where more than 30% cover of crop residue remains.

Do not graze livestock in areas of application. Do not use treated crops for feed.

If heavy rainfall is predicted, aerial or ground applications to corn are prohibited.

Per season, use no more than 0.1 lb. A.I./A. in all at-plant applications.

Spacing of Rows:

40 inches: 0.060 lbs a.i. / acre (3.9 oz / acre)

38 inches: 0.064 lbs a.i. / acre (4.1 oz / acre)

36 inches: 0.069 lbs a.i. / acre (4.4 oz / acre)

30 inches: 0.080 lbs a.i. / acre (5.12 oz / acre)

Pre-Harvest Interval

30 days

Restricted Entry Interval

12 hours

Timings