General Information


Apply the product to deliver the active ingredient into the seed or root-zone of crop. Failure to place the product into root-zone may result in loss of control or delay in onset of activity. The product may be applied with ground or chemigation application. DO NOT apply with aerial application equipment. Broadcast, foliar applications are only recommended to seedling flats or trays, or where product is intended to be washed from foliage to soil prior to drying on foliage.

Optimum activity results from applications to the root-zone of plants to be protected. The earlier the product is available to a developing plant, the earlier the protection begins. The product is continuously taken into the roots over a long period of time and the systemic nature of the product allows movement from roots through the xylem tissue to all vegetative parts of the plant. This results in extended residual activity, the control of insects and the prevention and/or reduction of virus transmission or symptom expression, and plant health benefits. The rate applied affects the length of the plant protection period. The higher specified rates are intended for when infestations occur later in crop development, or where pest pressure is continuous. The product will generally not control insects infesting flowers, blooms or fruit. Additional crop protection may be required for insects feeding in or on these plant parts and for insects not listed in the crop-specific, pests controlled sections of the label. Suppression, or less than adequate control of certain diseases and insect pests including reduced feeding, may also result from applications of the product. Adequate control of these pests/diseases may require supplemental control measures.

Use of the product on crops grown for production of true seed intended for private or commercial planting is not permitted unless allowed under State specific supplemental labeling. As with any insecticide, care must be taken to minimize exposure of the product to honey bees and other pollinators. Avoid use of the product on crops requiring bee pollination during bloom and a minimum of 10 days prior to bloom. Additional information on the product uses for these crops and other questions may be obtained from the Cooperative Extension Service, PCAs, or local Nufarm representatives.

Pre-mix with water or other appropriate diluent prior to application. Keep the product and water suspension agitated to avoid settling.

DO NOT apply more than 0.5 lbs active ingredient per acre, per year, regardless of formulation or method of application, unless specified within a crop-specific, Application Instructions section for a given crop.

Limitations, Restrictions, and Exceptions



Apply specified dosage of the product in one of the following methods:

1. Chemigation into root-zone through low-pressure drip, trickle, micro-sprinkler or equivalent equipment. For optimum results, apply to newly planted trees or those previously trained to drip, trickle or micro-sprinkler irrigation. Soil should be lightly pre-wetted to break soil surface tension prior to applications of the product. Chemigation application can be made separate to normal irrigation but followed by 10 to 20 minutes of additional watering to move the product into root-zone. Allow 24 hours before initiating subsequent irrigations;

2. Soil surface band spray on both sides of the tree. Bands should overlap at the tree base to create a continuous band within the drip-line area of the tree, to be followed immediately with light sprinkler irrigation sufficient to move the product into the upper portion of the root-zone. This method is suitable for very coarse soils with 0.75% organic matter or less;

3. Drench to base of tree not exceeding one-quart total solution per tree immediately around trunk of tree and extending outward covering the entire fibrous root system of the tree. Only recommended for trees up to 8 feet tall;

4. For control of existing termite infestations, apply specified dosage in 1 to 4 quarts of total solution volume, depending on size of tree, as a drench application to the basal portion of the tree trunk and surrounding soil in the immediate vicinity of the tree trunk;

5. For suppression of citrus nematode, apply specific dosage through low pressure chemigation or soil surface spray only, ensuring complete coverage of the root system and utilizing application directions stated for the respective application method.

Important Notes:

Repeated and regular use of the product over several consecutive growing seasons provides the greatest degree of nematode suppression and yields the greatest plant response.

Pests / Diseases Suppressed

Citrus nematode

Symptoms of: Citrus tristeza virus (CTV) through vector control, Citrus yellows, Thrips (foliage-feeding thrips only)

Restricted Entry Interval

12 hours

Exception: If the product is soil-injected or soil-incorporated, the Worker Protection Standard, under certain circumstances, allows workers to enter the treated area if there will be no contact with anything that has been treated.