NON-CROP AREAS - HIGH VOLUME FOLIAR APPLICATIONS

General Information

DIRECTIONS FOR USE

It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

Gordon’s Brushmaster Herbicide is recommended to control perennial broadleaf weeds and undesirable woody plants established in noncropland. It is effective for buckbrush, poison ivy, multiflora rose, and sumac established in the uncultivated areas presented below:

UNCULTIVATED AGRICULTURAL AREAS AND UNCULTIVATED NONAGRICULTURAL AREAS:

Recommended Noncropland Sites.

- Barrier strips

- Farmyards

- Fencerows or fence lines

- Firebreaks

- Highway rights-of-way (principal, interstate, county, private, and unpaved roads): Roadsides, roadside ditches, road shoulders, road embankments, dividers, and medians.

- Industrial sites: Lumberyards, tank farms, fuel or equipment storage areas.

- Municipal, state, and federal lands: Airports and military installations

- Railroad rights-of-way

- Recreation areas: Fairgrounds, golf courses, parks, and areas adjacent to athletic fields.

- Utility rights-of-way: Telephone, pipeline, electrical powerlines, and communication transmission lines

Applications to non-cropland areas are not applicable to treatment of commercial timber or other plants being grown for sale or other commercial use, or for commercial seed production, or for research purposes.

Prohibitions for Noncropland Sites.

- Do not apply to any body of water such as lakes, streams, rivers, ponds, reservoirs, or estuaries (salt water bays). Do not apply to any shorelines (noncropland sites adjacent to the edges of a body of water) for lakes, streams, rivers, ponds, reservoirs, or estuaries (salt water bays).

- Do not apply to wetlands (swamps, bogs, potholes, or marshes).

- Do not apply to agricultural irrigation water or on agricultural irrigation ditchbanks and canals.

- Do not apply to agricultural drainage water or on agricultural ditchbanks.

Limitations, Restrictions, and Exceptions

NON-CROP AREAS

Broadcast Foliar Applications:

- Spray Preparation - Add one-half of the required amount of water to the spray tank, then add slowly Gordon’s Brushmaster Herbicide with agitation, and complete filling the tank with water. To prevent separation of the emulsion, mix thoroughly and continue agitation while spraying.

High volume foliar applications (100 to 400 gallons per acre):

- Apply 1.0 to 4.0 gallons of product per acre with adequate water or apply a 1.0 to 4.0% vol/vol spray solution as a full cover spray with high volume equipment. Use the lower spray concentrations in the range for susceptible species and use the higher spray concentrations within the range for hard-to-control species, for mature plants during the late summer or under adverse environmental conditions (e.g. drought).

- Spray broadleaf weeds, woody plants or mixed brush uniformly and thoroughly by wetting all leaves, stems, bark and root collars. The total volume of spray solution required for adequate coverage of solid stands of mixed brush can range from 100 to 400 gallons of spray solution per treated acre. The spray preparation chart for applications on a spray-to-wet basis is shown on Table 1 of the label.

USE PRECAUTIONS FOR ALL METHODS OF APPLICATION:

- Do not apply this product through any type of irrigation system.

- Do not apply when temperatures exceed 85°F and humidity is high.