Atrazine 4L herbicide controls* many annual broadleaf and grass weeds in the crops included on the label. Atrazine 4L may be applied before or after weeds emerge.
*Important Note: Following many years of continuous use of this product and chemically related products, biotypes of some of the weeds listed on the label have been reported which cannot be effectively controlled by this and related herbicides. These weeds may include Lambsquarters, Pigweed, Black nightshade, Kochia, and others. Where this is known or suspected, we recommend the use of this product in combination with other registered herbicides which are not triazines. Consult your State Agricultural Extension Service about specific weed resistance to atrazine in your area and weed control recommendations. Within the specific crop directions on the label, certain weeds are indicated for suppression only. Weed suppression is a visual reduction in weed competition (reduced population and/or vigor) as compared to an untreated area. Degree of suppression will vary with rate used, size of weeds, and environmental conditions following treatment.
In each case where a range of rates is given, the lower rate should be used on light soils low in organic matter, and the higher rate should be used on heavy soils high in organic matter.
Since Atrazine 4L acts mainly through root absorption, its effectiveness depends on rainfall or irrigation to move it into the root zone. Should weeds develop, a shallow cultivation or rotary hoeing will generally result in better weed control. Care should be taken to avoid using Atrazine 4L where adjacent desirable trees, shrubs, or plants might be injured.
Note: Loveland Products, Inc. does not recommend the use of Atrazine 4L in combination with other herbicides or oils except as specifically described on the label or other literature distributed by Loveland Products, Inc.
For the most uniform distribution of broadcast applications use 80° flat fan type nozzles. For band applications, use flat fan even spray nozzles. Screens and strainers should be no finer than 50 mesh. Use a pump with capacity to (1) provide sufficient hydraulic agitation during mixing and application to keep the material in suspension and (2) maintain 35-40 psi operating pressure. Use a minimum of 5.0 gallons of water per acre for preplant incorporated, pre-emergence and post (without oil or surfactant) applications. Use a minimum of 10.0 gallons of water per acre for all postemergence applications combined with oil or surfactant.
Refer to the label for band applications to calculate the amount to be applied per acre.
For preplant and pre-emergence broadcast treatments, apply at a 1:1 ratio of Atrazine 4L to water (example: recommendation calls for 1.0 quart of product and is mixed with 1.0 quart of water) to be applied per acre. For postemergence treatments, on corn and sorghum, apply the specified rate of Atrazine 4L or Atrazine 4L plus oil in a minimum of 2.0 gallons of water per acre. Avoid applications under conditions where uniform coverage cannot be obtained or where excessive drift may occur.
Avoid application directly to animals. Flagmen or loaders should avoid inhalation of spray mist.
With fixed-wing aircraft or helicopter application, an exactly even swath deposition cannot be achieved, and consequently crop injury or pesticide nonperformance may result wholly or in part. Do not apply by air during periods of thermal inversion.
Refer to the label for tank mix information.
For control of annual broadleaf and grass weeds such as Barnyardgrass, Witchgrass (Panicum capillare), Yellow foxtail, Green foxtail, Wild oats, Large (Hairy) crabgrass, Velvetleaf, Morningglory, Lambsquarters, Ragweed, Nightshade, Purslane, and Mustard, in Douglas fir, Grand fir, Noble fir, White fir, Austrian pine, Bishop pine, Jeffrey pine, Knobcone pine, Loblolly pine, Lodgepole pine (Shore pine), Monterey pine, Ponderosa pine, Scotch pine, Slash pine, Blue spruce, and Sitka spruce.
Broadcast 4.0 to 8.0 pints in a minimum of 5.0 gallons of water per acre by air or 10.0 gallons by ground prior to transplanting, soon after transplanting, or in established Conifers between fall and early spring while trees are dormant. Apply before weeds are 1.5 inches tall. For applications prior to transplanting allow sufficient precipitation to activate Atrazine 4L before transplanting. In areas where spring and summer rainfall is inadequate to activate Atrazine 4L, apply during fall prior to spring transplanting.
Barnyardgrass, Witchgrass, Yellow foxtail, Green foxtail, Velvetleaf, Lambsquarters, Nightshade: Local resistance may result in suppression only or lack of control. Refer to IMPORTANT NOTE within PRODUCT INFORMATION SECTION of the label.
- In areas west of Rocky Mountains (except Great Basin), grazing may begin 7 months after a fall application or 3 months after a winter or spring application.
- To prevent illegal residues, do not graze treated areas of the Great Basin, or areas east of the Rocky Mountains.
- Apply only once per year.
- Temporary injury to trees may occur following use on coarse-textured soil.
- To avoid crop injury, do not apply to seedbeds.