WHEAT AND BARLEY - ID, MN, MT, ND, OR, SD, WA, WY
Axial Herbicide is a systemic, postemergence herbicide for the control of several grass weed species in all varieties of spring wheat (excluding durum), winter wheat, and barley.
Axial Herbicide is rapidly absorbed by weed foliage and translocated to the growing points of leaves and stems where it inhibits the acetyl CoA carboxylase (ACCase) enzyme. Susceptible weed species generally stop growing within 48 hours of treatment, turn yellow within one to three weeks, and are completely controlled within three to five weeks. Level and rate of control depend on weed species, growing conditions, crop competition, and coverage. Thorough spray coverage of the plants is essential for consistent control.
Although Axial Herbicide does not control broadleaf weeds, it can be tank mixed with a wide range of broadleaf herbicides to provide broad-spectrum one-pass weed control. It can also be tank mixed with Tilt Fungicide, Quilt Fungicide, and Warrior Insecticide with Zeon Technology (restriction: not for use on barley). See the section entitled Tank Mixes of Axial Herbicide with Broadleaf Weed Herbicides, Fungicides, and Insecticides. Herbicides not approved on the label for tank mixing with Axial Herbicide may be applied sequentially. Always apply Axial Herbicide first and allow at least 4 days after application of Axial Herbicide before applying these herbicides sequentially.
Apply the recommended rate of Axial Herbicide and the recommended rate of Adigor Adjuvant using ground or aerial equipment, in a minimum of 5 gals. of water per acre (see Ground and Aerial Application Procedures section for additional information).
Timing of Application
Apply Axial Herbicide to all varieties of spring wheat (excluding durum), winter wheat, and barley from the 2-leaf stage to pre-boot stage. Refer to the Crop Use Directions section for grazing and harvest restrictions.
Precaution: Do not apply to a crop that is stressed by conditions such as frost, low fertility, drought, flooding, disease damage, or insect damage, as crop injury may result.
When tank mixing with a broadleaf herbicide, insecticide or fungicide, always refer to the label of the tank mix partner prior to use.
For optimum results, apply Axial Herbicide to actively growing weeds. An early application will maximize crop yields by reducing weed competition. Weed control following application of Axial Herbicide alone or in combination with broadleaf herbicides can be reduced or delayed under conditions of stress, such as drought, heat, insufficient fertility, flooding, and prolonged cool temperatures. Grass escapes or re-tillering may occur if application is made during prolonged conditions of stress. Optimum weed control will be obtained if application of Axial Herbicide is delayed until the conditions of stress have ended and weeds are once again actively growing. Weeds emerging after Axial Herbicide application will not be controlled.
Water Volume – Use an application rate of 5–10 gals. of water per acre. Use 10 gals. of water per acre under dry conditions or dense weed populations. Application rates of greater than 10 gallons of water per acre should be avoided as reduced grass control may occur.
Apply Axial Herbicide in water using a minimum spray volume of 5 gals./A. Avoid application under conditions where uniform coverage cannot be obtained or where excessive spray drift may occur. Make applications at a maximum height of 10 ft. above the crop with low-drift nozzles at a maximum pressure of 40 psi and wind speed not exceeding 10 mph to help assure accurate application within the target area.
Wheat and Barley
For control of wild oat, volunteer oat, green foxtail, yellow foxtail, Italian ryegrass and broadleaf weeds, (refer to the broadleaf tank mix partner label for weeds controlled), use Axial at 8.2 oz./A + Adigor Adjuvant at 9.6 oz./A plus one of the following two-way broadleaf herbicide combinations.