ON ALMONDS, PEANUTS AND WALNUTS IN BULK OR IN BAGS

General Information

For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.

Pyrenone Crop Spray is relatively non-toxic to Honey Bees. To maximize this benefit, apply early in the morning or late in the evening.

USE THROUGH IRRIGATION SYSTEMS (CHEMIGATION):

Refer to supplemental labeling entitled DIRECTIONS FOR APPLICATION THROUGH IRRIGATION SYSTEMS (available through your distributor) for use directions for chemigation. Do not apply this product through any irrigation system unless the supplemental labeling on chemigation is followed. Pyrenone Crop Spray may be used on most crops because its active ingredients are exempt from tolerances when applied to growing crops. The crop grouping scheme used on the label was devised by the Environmental Protection Agency to expedite minor use pesticide registration. Each crop grouping on the label contains the phrase “including, but not limited to,” and then lists a number of crops in each group. This wording allows the use of Pyrenone Crop Spray on crops that may not be specifically listed on the label (providing that the group to which the crop belongs is listed).

Limitations, Restrictions, and Exceptions

ON ALMONDS, PEANUTS AND WALNUTS IN BULK OR IN BAGS

To control stored product insects including, but not limited to, Almond Moths, Angoumois Grain Moths, Ants, Cadelles, Cigarette Beetles, Confused Flour Beetles, Drugstore Beetles, Flat Grain Beetles, Granary Weevils, Indianmeal Moths, Lesser Grain Borers, Maize Weevils, Mediterranean Flour Moths, Merchant Grain Beetles, Red Flour Beetles, Rice Weevils, Rusty Grain Beetles, Sawtoothed Grain Beetles And Squarenecked Grain Beetles, dilute 1.33 ounces of Pyrenone Crop Spray per gallon of water and apply as a coarse wet spray over the top of stored nuts or the outside surface of stacked bagged nuts at the rate of 4 gallons per 1000 square feet. Apply at weekly intervals for about 6 weeks and then at 15-day intervals. The first two applications should be applied at the rate of 4 gallons per 1000 square feet and subsequent treatments should be applied at the rate of 2 gallons per 1000 square feet.

Method
Restricted Entry Interval

12 hours

Timings