USE ON TURF AND GRASS
For any requirements specific to your State or Tribe, consult the agency responsible for pesticide regulation.
Pyrenone Crop Spray is relatively non-toxic to Honey Bees. To maximize this benefit, apply early in the morning or late in the evening.
USE THROUGH IRRIGATION SYSTEMS (CHEMIGATION):
Refer to supplemental labeling entitled DIRECTIONS FOR APPLICATION THROUGH IRRIGATION SYSTEMS (available through your distributor) for use directions for chemigation. Do not apply this product through any irrigation system unless the supplemental labeling on chemigation is followed. Pyrenone Crop Spray may be used on most crops because its active ingredients are exempt from tolerances when applied to growing crops. The crop grouping scheme used on the label was devised by the Environmental Protection Agency to expedite minor use pesticide registration. Each crop grouping on the label contains the phrase “including, but not limited to,” and then lists a number of crops in each group. This wording allows the use of Pyrenone Crop Spray on crops that may not be specifically listed on the label (providing that the group to which the crop belongs is listed).
USE ON TURF AND GRASS
- Dilute with enough water to obtain thorough coverage.
- 43560 square feet = 1 acre.
USED IN COMBINATION WITH OTHER INSECTICIDES:
To provide quick knockdown of insects when used with a residual insecticide, tank-mix Pyrenone Crop Spray with the proper amount of companion insecticide and apply at the rates listed above.
Applications must be made in accordance with the more restrictive of label limitations and precautions.
No label application rates may be exceeded. This product cannot be mixed with any product with label prohibitions against such mixing.
USED AS A TURF PEST DIAGNOSTIC AID:
To detect turf insects prior to making an insecticide application or to evaluate control from previous treatments, dilute one tablespoon of Pyrenone Crop Spray per gallon of water and apply evenly with a sprinkling can over one square yard of turf. Record the species and number of insects present ten minutes after application. Sample 3 to 5 sites per 5000 square feet. Note: this procedure does not bring white grubs or billbug grubs to the surface.
Use other methods to sample for these pests.