LAWNS - ARMYWORM, CUTWORM AND SOD WEBWORM CONTROL
General Application Instructions
Not for use on plants being grown for sale or other commercial use, or for commercial seed production, or for research purposes. For use on plants intended only for aesthetic purposes or climatic modifications and being grown in interior plantscapes, ornamental gardens or parks, or lawns and grounds.
Bifenthrin Pro Insecticide/Miticide formulation mixes readily with water and other aqueous carriers, and controls a wide spectrum of insects and mites on trees, shrubs, foliage plants, non-bearing fruit and nut trees, and flowers in interiorscapes including hotels, shopping malls, office buildings, etc., and, outdoor plantscapes, such as around residential dwellings, parks, institutional, buildings, recreational areas, athletic fields and home lawns. Non-bearing crops are perennial crops that will not produce a harvestable raw agricultural commodity during the season of application.
Only for Use and Storage by Commercial Applicators. To control insect pests and mites indoors, in interiorscapes and outdoors on ornamentals and lawns in landscaped areas around residential, institutional, public, commercial, and industrial buildings, parks, recreational areas and athletic fields.
Do not apply by air.
Do not apply in greenhouses and nurseries.
Not for use on sod farm turf, golf course turf, or grass grown for seed.
For mixing application instructions of Befenthrin Pro with other products, please refer to the label.
Use application volumes of up to 10 gallons per 1,000 square feet to get uniform coverage when treating dense grass foliage.
For low volume applications, less than 2 gallons/ 1,000 square feet, immediate irrigation of treated area with at least 0.25 inches of water following application is recommended to ensure efficacy of sub-surface pests such as, but not limited to, Mole Crickets.
Lawn Application Rate
The specified rate will provide excellent control of the respective pests under typical conditions. However, at the discretion of the applicator, Bifenthrin Pro Insecticide/Miticide may be applied at up to 1 fluid oz. per 1,000 square feet to control each of the pests. The higher application rates should be used when maximum residual control is desired.
Armyworms, Cutworms and Sod Webworms: To ensure optimum control, delay watering (irrigation) or mowing for 24 hours after application. If the grass area is being maintained at a mowing height of greater than 1 inch, then higher application rates (Up to 1 fluid oz. per 1,000 square feet) may be required during periods of high pest pressure.
- For Bifenthrin Pro Insecticide/Miticide lawn dilution chart, please refer to the label.