DRY BEANS, ETC. - BROADLEAVES

General Information

General Information

The tank mix of Rezult B + Rezult G herbicides is intended for the postemergence control of a wide spectrum of broadleaf and grass weeds in dry beans, dry peas, peppermint, soybeans, spearmint, and in Poast Protected field corn or corn grown for Poast Protected seed.

Rezult B and Rezult G are provided in individual bulk, mini-bulk and one-gallon containers.

Always read and follow all label directions when using any pesticide alone or in tank mix combinations. The most restrictive labeling applies when using a tank mix.

Mode of Action:

Rezult B + Rezult G is effective through postemergence contact and systemic activity. Weeds must be thoroughly covered with spray. Large crop-and-weed-leaf canopies shelter smaller weeds and prevent adequate spray coverage.

Crop Tolerance:

All soybean varieties are tolerant to Rezult B + Rezult G at all stages of growth. Leaf speckling may occur, but plants generally outgrow this condition within 10 days.

Only Poast Protected field corn hybrids are tolerant to Rezult B + Rezult G applications. Severe crop injury will occur to corn hybrids not labeled as Poast Protected field corn.

In dry beans and dry peas, apply Rezult B + Rezult G early postemergence to listed actively growing weeds before they reach the maximum size. Apply to dry beans after the first trifoliate leaf has fully expanded and after dry peas have at least three (3) pairs of leaves or four (4) nodes. Applications prior to these stages may result in severe crop injury. Dry bean and dry pea injury can be very pronounced. Even at the tolerant stages, yellowing, bronzing, speckling or burning of leaves may occur under certain conditions. This temporary injury is generally outgrown without delaying podset or maturity or reducing yield. Using oil with Rezult B + Rezult G may increase injury and may reduce yields. Tolerant bean and pea types are adzuki bean, navy bean, pinto bean, pink bean, great northern bean, kidney bean, red bean, white bean, cranberry bean, black turtle soup bean, dry lima bean, dry snap bean, and dry edible peas (field peas).

In Western irrigated dry bean areas, it may be necessary to irrigate prior to application of Rezult B + Rezult G to ensure that weeds are actively growing. Weeds that are growing under moisture stress are not actively growing and will not be satisfactorily controlled. In this irrigated area, avoid applying Rezult B + Rezult G during prolonged periods of cold weather (day temperature below 75° and night temperature below 55° for 2-5 days) because weed control may be reduced.

Peppermint and spearmint are tolerant to Rezult B +Rezult G, however, some leaf burning may occur under certain conditions, such as when plants are growing very actively and have extensive new, succulent tissue. Peppermint and spearmint plants generally outgrow this condition within 10 days.

Essentially, all grass crops such as sorghum, non-Poast Protected corn and small grain, as well as ornamental grasses such as turf, are susceptible to Rezult B + Rezult G herbicides; therefore, avoid all direct or indirect contact with any grass crop.

Cultivation:

DO NOT cultivate within 5 days before applying Rezult B + Rezult G or within 7 days after application. Cultivation may put weeds under stress and reduce control.

A timely cultivation 7 days after applying Rezult B + Rezult G may provide season-long weed control.

Application Instructions

Application Rate and Timing

Apply 3.2 pints of Rezult B + Rezult G per acre (1.6 pints of Rezult G per acre + 1.6 pints of Rezult B per acre) early postemergence to actively growing weeds before they reach the sizes listed in Table 1.

DO NOT apply Rezult B and Rezult G in any combination other than a 1:1 ratio.

Rezult B + Rezult G can be applied at a maximum total rate of 3.2 pints per acre (1.6 pints of Rezult G per acre + 1.6 pints of Rezult B per acre).

An additional 2 pints of Basagran herbicide per acre may be applied after a single application of Rezult B + Rezult G.

In dry beans and dry peas, an additional 2.9 pints of Poast herbicide per acre may be applied after a single application of Rezult B + Rezult G.

In soybeans, an additional 5.9 pints of Poast Plus herbicide per acre may be applied after a single application of Rezult B + Rezult G.

In peppermint and spearmint, an additional 3.9 pints of Poast per acre maybe applied after a single application of Rezult B + Rezult G.

In Poast Protected field corn, an additional 2.9 pints of Poast Plus per acre may be applied after a single application of Rezult B + Rezult G.

Ground Application: Use a minimum of 10 gallons of water per broadcast acre at 60 psi (measured at the boom, not at the pump or in the line) to ensure adequate spray coverage. When crop and weed foliage is dense, use up to 20 gallons of water at 40-60 psi. Use standard high-pressure hollow cone or flat fan nozzles spaced 20 inches apart. DO NOT use flood or whirl chamber nozzles. Brass nozzles are not recommended because of the corrosive effects of nitrogen additives.

At lower volumes (e.g., 10 gallons of spray volume per acre) use a minimum nozzle size of 8002 or equivalent to minimize spray drift.

Air Application: Use a minimum of 5 gallons of water per acre and a maximum of 40 psi pressure. To obtain uniform coverage and to avoid drift hazards, the following application equipment and practices should be used:

Nozzle type: Use only diaphragm-type nozzles producing cone or fan spray patterns.

Nozzle height: Maximum of 10 feet above the crop.

Nozzle orientation: Nozzles must be oriented to discharge straight back with the air stream (opposite the direction of travel of the aircraft) or at some angle between straight back and straight down.

Nozzles must be located no farther than 3/4 the distance from the center of the aircraft to the end of the wing or rotor.

DO NOT apply Rezult B + Rezult G by aircraft within 200 feet upwind of ornamental or sensitive nontarget crops such as non-Poast Protected corn, cotton, small grains, sugar beets, or sunflowers. Applicator must follow the most restrictive use cautions to avoid drift hazard and must follow labeling as well as applicable state and local regulations and ordinances.

Limitations, Restrictions, and Exceptions

For the \"Maximum Weed Heights Controlled by the tank mix of Rezult B and Rezult G herbicides at the labeled rates (Rezult B + Rezult G can be applied at a maximum rate of 3.2 pints per acre (1.6 pints of Rezult B per acre + 1.6 pints of Rezult G per acre)) in Dry Beans, Dry Peas, Peppermint, Soybeans, Spearmint, and in Poast Protected Field Corn, refer to Table 1 of the label.

Maximum Adjuvant rate (per acre): 1 pint of crop oil concentrate or spray additive + 1-2 quarts of UAN solution (AMS can be substituted at 1-2 pounds per acre.).

Wild Sunflower: For regrowth or new germination, follow up 7-10 days later with Basagran herbicide. Refer to Basagran label.

Restrictions and Limitations

DO NOT apply the tank mix of Rezult B and Rezult G herbicides to labeled crops under stress due to lack of moisture, previous herbicide injury, mechanical injury, or cold temperatures, as crop injury may result.

DO NOT apply to weeds under stress, such as stress due to lack of moisture, previous herbicide injury, mechanical injury or cold temperatures, as unsatisfactory control could result.

DO NOT apply if rainfall or irrigation is expected within one hour following application. Physical incompatibility, reduced weed control, or crop injury may result from mixing Rezult B + Rezult G with other pesticides (fungicides, herbicides, insecticides or miticides), additives or fertilizers not recommended on the label. BASF does not recommend the use of Rezult B + Rezult G in tank mixes other than those listed on BASF labels, supplemental labels, or technical bulletins. Local agricultural authorities may be a source of information when using other than BASF recommended combinations.

DO NOT apply Rezult B + Rezult G as a preplant or preemergent treatment prior to corn, millet, sorghum, or small grain crops.

DO NOT apply Rezult B + Rezult G through any type of irrigation system.

DO NOT apply Rezult B + Rezult G to dry beans or dry peas within 30 days of harvest. In dry beans and dry peas, DO NOT apply more than 2 pints of Basagran herbicide or 2.9 pints of Poast herbicide per acre after an application of 3.2 pints of Rezult B + Rezult G per acre in one season.

DO NOT apply Rezult B + Rezult G to dry bean fields until beans have at least the first trifoliate leaf fully expanded or to dry pea fields before dry peas have at least 3 pairs of leaves (4 nodes) because severe crop damage may occur.

DO NOT apply Rezult B + Rezult G to dry peas under stress from root rot.

DO NOT apply Rezult B + Rezult G to garbanzo beans or lupines at any stage of growth, as severe crop damage may occur. Not recommended for use on adzuki beans in California.

DO NOT apply Rezult B + Rezult G to peppermint or spearmint within 20 days of harvest.

DO NOT apply Rezult B + Rezult G herbicides to soybeans within 75 days of harvest.

DO NOT graze treated soybean fields and DO NOT feed treated soybean forage (green succulent) or ensilage to livestock.

DO NOT cut treated soybean fields for hay for at least 30 days after the last treatment of Rezult B + Rezult G. Only processed meal from seed or hay may be fed to animals.

DO NOT apply Rezult B and Rezult G in any combination other than a 1:1 ratio.

In soybeans, DO NOT apply more than 2 pints of Basagran or 5.9 pints of Poast Plus herbicide per acre after an application of 3.2 pints of Rezult B + Rezult G per acre in one season.

DO NOT apply more than a total of 3.2 pints of Rezult B + Rezult G per acre in one season.

DO NOT apply more than a total of 2 pounds of bentazon active ingredient (a.i.) from all sources per acre per calendar year.

DO NOT apply Rezult B + Rezult G to corn hybrids which are not specifically labeled as Poast Protected field corn because severe crop injury will occur. Over-the-top applications of Rezult B + Rezult G in Poast Protected field corn may be made until the onset of pollen shed. DO NOT apply Rezult B + Rezult G after pollination occurs.

DO NOT apply Rezult B + Rezult G to Poast Protected field corn within 60 days of harvest of corn grain or fodder.

DO NOT apply Rezult B + Rezult G to Poast Protected field corn within 45 days of harvest of corn forage/silage. In Poast Protected field corn, DO NOT apply more than 2 pints of Basagran or 2.9 pints of Poast Plus per acre after an application of 3.2 pints of Rezult B + Rezult G per acre in one season.

DO NOT graze treated Poast Protected field corn fields for at least 12 days after the last treatment of Rezult B + Rezult G. In peppermint and spearmint, DO NOT apply more than 2 pints of Basagran or 3.9 pints of Poast per acre after an application of 3.2 pints of Rezult B + Rezult G per acre in one season.

Restricted Entry Interval

48 days