WALNUT - WALNUT BLIGHT

General Information

GENERAL INFORMATION

Use this product according to \"DIRECTIONS FOR USE\". This product can be applied from aircraft and ground spraying equipment. Depending upon equipment used and the specific crop, the volume applied per acre differs. Refer to the general \"MINIMUM RECOMMENDED SPRAY VOLUME\" table in the label.

CROPS

The specific instructions are based on general application procedures. The recommendations of the State Agricultural Extension Service should be closely followed as to timing, frequency and number of sprays per season.

APPLICATION FOR FROST INJURY PROTECTION

Bacterial Ice Nucleation Inhibitor: Application of this product made to all crops listed on the label at rates and stages of growth indicated on the label, at least 24 hours prior to anticipated frost conditions, will afford control of ice nucleating bacteria (Pseudomonas syringae, Erwinia herbicola and Pseudomonas fluorescens) and may thereby provide some protection against light frost. The degree of frost protection will vary with weather conditions and other factors. Not recommended for those geographical areas where weather conditions favor severe frost.

Limitations, Restrictions, and Exceptions

WALNUT - WALNUT BLIGHT

USE INSTRUCTIONS: Apply first application spray at early prebloom prior to when catkins are partially expanded. Make additional applications during bloom and early nutlet stage or as needed when free moisture occurs. Thorough coverage of catkins, leaves and nutlets is essential for effective control. When applied as a dilute spray, 1 pint of Summer oil emulsion may be added per 100 gallons of spray.

Note: Adequate control may not be obtained when copper tolerant species of Xanthomonas bacteria are present.

Restricted Entry Interval

24 hours