NON-CROP USE ON RIGHT-OF-WAY SITES - PREEMERGENCE

General Information

GENERAL USE INFORMATION

Unless otherwise directed by registered supplemental labels, follow the Directions for Use in each crop group section.

IMPORTANT: Read the entire DIRECTIONS FOR USE and the LIMITATION OF WARRANTY AND LIABILITY before using this product. If terms are not acceptable, return the unopened product container to the place of purchase at once.

When an adjuvant is to be used with this product, Makhteshim Agan of North America, Inc. suggests the use of a Chemical Producers and Distributors Association certified adjuvant.

IMPORTANT: TREATED SOIL MUST BE THOROUGHLY INCORPORATED TO A DEPTH OF 4 INCHES AFTER HARVEST (OR ABANDONING) OF THE TREATED CROP BUT PRIOR TO PLANTING OF THE ROTATIONAL CROP. FAILURE TO ACHIEVE THIS THOROUGH AND COMPLETE INCORPORATION OR TO FOLLOW THE REQUIRED MINIMUM PLANT-BACK INTERVAL MAY RESULT IN CROP INJURY, STAND REDUCTION, AND/OR VIGOR REDUCTION OF THE PLANT-BACK CROP. See specific fallow bed labeling regarding crop planting information for applications of GALIGAN 2E made to a fallow bed or fallow field.

GENERAL USE RESTRICTIONS

USE RESTRICTIONS THAT APPLY TO ALL REGISTERED APPLICATIONS ARE LISTED BELOW:

- Read and observe all label directions before using. When tank mixing, always read all individual manufacturers' labels. In interpreting all labels for the tank mixture, the most restrictive situations must apply.

- Do not contaminate irrigation water or water used for domestic purposes.

- Do not use any plants treated with GALIGAN 2E herbicide for feed or forage.

- Do not feed or allow animals to graze on any areas treated with GALIGAN 2E herbicide.

- GALIGAN 2E herbicide should be applied only by ground application equipment except as specifically directed on the label or on other approved supplemental labeling.

- Do not apply when weather conditions favor drift. Avoid drift to all nontarget areas. GALIGAN 2E herbicide is phytotoxic to plant foliage.

- Thoroughly flush spray equipment (tank, pump, hoses, and boom) with clean water before and after each use. Residual GALIGAN 2E herbicide remaining in spray equipment may damage other crops. To assist in the removal of GALIGAN 2E herbicide residues in spray equipment, a non-ionic surfactant such as Latron AG-98 or Latron CS-7 may be added at the rate of 1 quart per 100 gallons of water during flushing.

- Use GALIGAN 2E herbicide only for recommended purposes and at recommended rates.

- Do not treat ditch banks or waterways with GALIGAN 2E herbicide.

- On all labeled food and/or feed crops, the maximum seasonal application rate is 1.5 lbs. active ingredient (6 pints of this product) per acre (except tropical commodities grown in Hawaii).

- On all labeled ornamentals, the maximum application rate of 1.5 lbs. active ingredient (6 pints of this product) per application is allowed. A total of 4.5 lbs. active ingredient (18 pints of this product) is allowed per season.

- On all labeled conifer seedlings, the maximum application rate is 2 lbs. active ingredient (8 pints of this product) per acre.

Refer to the label regarding chemigation and tank mix information.

Limitations, Restrictions, and Exceptions

NON-CROP USE ON RIGHTS-OF-WAY SITES

GENERAL INFORMATION

GALIGAN 2E herbicide is recommended for postemergence and preemergence control of certain broadleaf weeds in non-crop areas.

TIMING AND METHOD OF APPLICATION

GALIGAN 2E should be applied in a minimum of 40 gallons of water per acre (10 gallons of water per acre for witchweed control in North and South Carolina). Best preemergence results are achieved when spray is applied to a relatively weed free soil surface. The volume of water used should be increased as the weeds become taller and more dense. Use a low-pressure sprayer equipped with flat fan nozzles. Spray equipment should be calibrated carefully before each use. The use of an 80% active nonionic surfactant should be added to the spray mixture at a rate of 0.125% v/v (1 pint per 100 gallons of spray mix) when using for the control of witchweed in North and South Carolina.

SPECIFIC USE RESTRICTIONS

In addition to the following, also observe GENERAL USE RESTRICTIONS listed at the beginning of the label.

- Do not feed or allow animals to graze on any areas treated with GALIGAN 2E herbicide.

WITCHWEED (North and South Carolina): Applications must be applied to witchweed plants before blooms form to prevent the production of viable seed.

Method
Restricted Entry Interval

24 hours