REVOKE is an effective contact insecticide, miticide and fungicide for control of soft bodied insects, mites and powdery mildew. This product may be used to control targeted pests on crops which include vegetables, grapes and other small fruits, tree fruits, tree nuts, cotton, tobacco, shrubs, shade and ornamental trees, turf, foliage and flowering plants growing outdoors, in greenhouses and in interiorscapes.
This product can be applied up to harvest.
This product may be used as a foliar spray to control or suppress soft bodied pests which include:
adelgids, aphids, caterpillars, earwigs, lace bugs, leafhoppers, leafminers, mealybugs, mole crickets, plant bugs, psyllids, sawfly larvae, scales, spider mites, tent caterpillar, thrips, whiteflies, gypsy moth, and chinch bugs. This product provides curative control of powdery mildew.
MIXING AND APPLICATION
Stand-alone rate: REVOKE rates as low a 0.25% v/v or as high as 4% v/v may be used. The 2%
v/v is the most frequently used stand-alone rate.
Refer to individual sections of the label for specific use rates for control of pests on specific crops.
Rates are provided as a % volume/volume (v/v) solution. A 2% v/v solution is prepared by adding 2 gallons of REVOKE to 98 gallons of spray water.
The activity of this product is directly related to the solution concentration and to contact with the pest, not to the amount of product applied per acre.
Tank-mix rate: To achieve enhanced and residual pest control, use a 1 to 2 % v/v solution of this
product in combination with a recommended product.
Timing of Application
Initiate applications as soon as pest is observed, or as needed to avoid economic injury. Repeat applications at one to two week intervals, or as needed, to control reinfesting or increasing pest populations.
Do not make repeat applications at less than 7 day intervals, or make more than 3 sequential applications at 7 to 14 day intervals unless your prior experience has shown the use pattern to be
non-injurious to the type and the developmental stage of plant(s) to be treated under local growing conditions.
This product may be applied with most types of ground or aerial spray equipment. Do not use with pulse or thermal fogger applicators. Do not apply through any type of irrigation system.
This product must come into contact with the targeted soft bodied pests or powdery mildew to be
effective. Complete coverage of pests is essential for maximum control. Direct sprays to contact
the pests. In general, adequate coverage requires a minimum of 50 gallons of total spray volume
per acre. Higher volumes may be required on larger perennial crops.
Apply REVOKE solutions to wet (minimize run-off) to decrease the potential for injury on foliage,
fruit and flowers of sensitive plants.
Apply promptly after mixing with other pesticides to avoid or reduce alkaline hydrolysis of certain
Avoid applications when wind conditions impair thorough coverage.
Avoid applications on new transplants and unrooted cuttings.
Refer to the MIXING AND APPLICATION section of the label for general rate, timing and application information except as noted.
Stand alone rate: Use 4 pints of this product per acre when applications are made in 3-25 gallons of water per acre. Use a 2% v/v spray solution of this product when 25 or more gallons of water are applied per acre.
When used in combination with other insecticides, use 0.75 to 4 pints of this product per acre when applied in 3-25 gallons of water per acre. Use a 1-2% v/v solution of this product when greater than 25 gallons of water are applied per acre.
To achieve enhanced and residual control of caterpillars, use this product in combination with recommended insecticides such as Baythroid, Bolstar and Orthene.
To achieve enhanced and residual control of other insects (aphids, thrips, greenbug, fleahoppers, plant bugs, spider mites, whiteflies), use this product in combination with recommended insecticides such as Bidrin, Thiodan, Phaser, Orthene, Asana, Capture or Zephyr.
In situations where thorough coverage of pests is not possible or practical, it is recommended that this product be tank-mixed with one of the companion pesticides listed above. This product may be used in tank-mixes with penetrator type adjuvants for application to cotton, peanuts and tobacco only if prior use under local use conditions has demonstrated plant safety.