GRAPES - POWDERY MILDEW - CALIFORNIA

General Information

PRODUCT INFORMATION

Liquid Sulfur Six is a flowable sulfur formulation that can be mixed with liquid fertilizers or water and applied by ground or air application. Consult your state or local extension specialist for additional treatment information.

Sulfur may cause injury if used improperly or under unfavorable weather conditions. During periods of high temperature Sulfur may burn foliage. Do not make Sulfur applications at such times.

NOTE: Sulfur will cause severe fruit and leaf injury to sulfur-sensitive crops. Do not apply or allow to drift to apricots, d'Anjou and Comice pears, cranberries, cucurbits (cucumber, cantaloupes, melons, squash), filberts, spinach, tung trees, walnuts or other sensitive plants.

DO NOT USE WITHIN FOUR (4) WEEKS OF AN OIL SPRAYING. SULFUR IS HIGHLY CORROSIVE, AND EQUIPMENT SHOULD BE CLEANED THOROUGHLY AFTER EACH DAY'S SPRAYING.

DIRECTIONS FOR MIXING BEFORE USING, STIR UNTIL SMOOTH Pour recommended amount in partially filled spray tank. Keep agitator running during filling and spraying operation. DO NOT ALLOW MIXTURE TO STAND. Failure to maintain agitation will cause Liquid Sulfur Six to settle and may necessitate manual stirring to redisperse.

RECOMMENDATIONS:

WHEN GROWING CROPS FOR PROCESSING, CONSULT THE PROCESSOR BEFORE APPLYING SULFUR.

Unless otherwise specified for specific crops, dosage rates are given as pints of Liquid Sulfur Six per 100 gallons water for use in a thorough coverage spray. The total amount of Liquid Sulfur Six per acre should be 2 to 4 gallons depending on the size of trees. Because of variations in the types of spray equipment used, a range of low and high rates is listed. For high-volume sprayers (output 800 to 1000 gallons spray per acre) use the low rate; for low-volume sprayers (output 20 to 300 gallons spray per acre) use the high rate.

DO NOT APPLY THIS PRODUCT THROUGH ANY TYPE OF IRRIGATION SYSTEM.

Limitations, Restrictions, and Exceptions

FIELD AND VINE CROPS

Unless otherwise specified for specific crops, dosage rates are given as pints of Liquid Sulfur Six per acre. This product should be applied by ground equipment or aircraft in sufficient water to provide thorough coverage.

GRAPES:

Applications in California, use 2-3 quarts per acre in enough water for thorough coverage or per 100 gallons of water in spring and summer applications. Make the first application when shoots are 6-8 inches long, the second when shoots are 12-15 inches long and the third at about bloom stage. Timing, rates, and number of applications vary with local conditions. Consult your state Agricultural Extension Service for specific recommendations.