FIELD CORN - FOLIAR APPLICATION - GRASSHOPPER
Soil Application Precautions
For standard planters and applications systems, do not start insecticide application until planter enters the soil, and stop insecticide application before pulling planter out of the soil. If contaminated seed is exposed to the surface cover completely with soil.
For standard planters equipped with in-furrow systems having automatic shut-off systems (e.g., Custom Delivery Systems (CDS), Custom Injection Systems (CIS)) be sure shut-off devices are maintained and operating properly.
DO NOT FLUSH, DRAIN OR PUMP TANK, LINES OR RINSATE ON NON-CROPLAND SURFACES. Dispose of residual spray mixture left in tank, line(s) and/or rinsate from first flushing of tank and line(s) by application to cropland as directed on the label.
Pints of Furadan 4F Per Acre (Do not cut or graze within)
0.5 pint/acre (7days)
1 pint/acre (14days)
2 pints/acre (28days)
- Refer to Cooperative Extension Pest Management Guidelines.
—Use the 0.25 pint rate under light to moderate population levels (0 to 14 grasshoppers per sq. yd.).
—Use the 0.54 pint rate under more severe population levels (15 or more grasshoppers per sq. yd.).
- Apply in sufficient water for thorough coverage using a minimum of 2 gallons of finished spray per acre with air equipment or 10 gallons of finished spray per acre with ground equipment.
- Do not make more than two foliar applications per season or more than one foliar application if Furadan 4F was used as a soil application pest
control treatment. Do not forage cut or harvest within 30 days of last application. Do not use Furadan 4F as a foliar treatment on seed corn.
- In areas having greater than 90% sand and less than 1% organic matter where the water table (groundwater) is shallow (less than thirty feet):
Do not make a foliar application if Furadan 4F was used as a soil application pest control treatment.