WHEAT AND BARLEY : PREHARVEST

General Information

GENERAL INFORMATION

638 is a special formulation containing 2,4-D acid. It is more effective than 2,4-D amines for controlling hard-to-kill weeds such as field bindweed, Russian knapweed, Canada thistle, leafy spurge, cattails, tules and nutgrass. 638 should be applied when daytime temperatures are lower than 80 to 85 degrees. Spraying when temperatures are higher may cause rapid foliar burn and decrease the product’s effectiveness. Treatment at higher temperatures also increases the possibility of crop injury. INJURY TO CROPS FROM THIS HERBICIDE MAY OCCUR. IF YOU ARE NOT PREPARED TO ACCEPT SOME DEGREE OF CROP INJURY, DO NOT USE THIS PRODUCT. Crop varieties vary in response to 2,4-D and some are easily injured. Apply 638 only to varieties known to be tolerant to 2,4-D. If you are uncertain concerning tolerant varieties or local use situations that may affect crop tolerance to 2,4-D, consult your seed company or state Agricultural Extension Service for advice.

GENERAL RESTRICTIONS:

Do not apply product through any type of irrigation system. Do not use in or near a greenhouse.

Limitations, Restrictions, and Exceptions

CEREAL GRAIN CROPS

WHEAT and BARLEY (not underseeded with legumes)

- Apply when grains are in the hard dough stage to suppress large weeds that may interfere with harvest. Best results will be obtained when soil moisture is sufficient to induce succulent weed growth.

- Beggarticks, common broomweed, knotweed, mallow (venice or little), musk thistle, prickly lettuce, Russian thistle, salsify (western or common), smartweeds (annual species),vervains, Alfalfa, Austrian fieldcress, bindweed (hedge,field, European), Canada thistle, docks, dogbanes, goldenrod, ground ivy, hoary cress, many-flower aster, nettles (including stinging), orange hawkweed, tansy ragwort, vervains, western ironweed, wild garlic, wild onion: These species may require repeat applications and/or use of higher rate recommended on this product label even under ideal conditions for application.

- Pigweeds (Amaranthus spp.): Control of pigweeds in the High Plains area of Texas and Oklahoma may not be satisfactory with this product.

Restrictions and limitations for use on cereal grains:

- For aerial application on grain, apply in 2 or more gallons of water per acre. For ground application, a minimum of 10-15 gallons of water per acre is recommended for proper spray coverage.

- Do not mix with oil for crop uses.

- Do not permit dairy animals or meat animals being finished for slaughter to forage treated grain fields within 2 weeks after treatment.

- Do not feed treated straw to livestock if a preharvest treatment or emergency treatment as described above is applied.

Method
Restricted Entry Interval

48 hours